Your cart is empty.
Your cart is empty.Installation Instructions 1. Flush Debris from pipelines thoroughly before fitting 2. Ensure valve is mounted horizontally in tank with outlet pointing down 3. Use thread seal tape on Inlet thread 4. Inject water into floats up to water limited line 5. Set level stopper at desired approximate lower on position and tie off cord at end of arm. (Use double hole end loop system for easy adjustment and tie off) 6. Ensure float is in correct position between stops 7. Set adjustable level adjuster for desired off position 8. Cut off excess cord to desired length
Jacky
Reviewed in the United States on September 4, 2024
The valve works great!Easy to install!I am glad to have bought the right valve ,and will buy more!
Rudy C.
Reviewed in the United States on September 18, 2024
Installed In a 2500 gallon water tank. So far, it works well and does what is shows in the videos for the product. However, some fine tuning was required to get just the right weight on the cable and just the right amount of water in the bottles. We shall see how long it lasts.All molded plastic construction exterior. I am not sure about the internal valve construction. For the high cost of a plastic part, this should work perfectly out of the box.
m coulter
Reviewed in the United States on August 24, 2024
Installs very easy & works well. Wish it came in a larger size. 1" is barely large enough. Long adjustment is very nice. Has been working very well in my 500 gallon tank for a month now. Great deal for the money.
Susan
Reviewed in the United States on December 24, 2024
Recommended Products
