Your cart is empty.
Your cart is empty.Product Description
Hold an Edge Well
Ultra-low temperature treated M2 HSS greatly improves wear resistance.The grinding cycle and service life are several times that of ordinary HSS
Pre-Sharpened
Pre-sharpened with CBN grinding wheels, ready to use right out of the box
Stainless Steel Ferrule
Fully wrapped stainless steel ferrule, the blade is tightly connected with the handle, high safety
UF-SHARP Large Spindle Roughing Gouge（28mm）
- Improved handle is longer and easier to operate
- Cryo M2 HSS can keep the edge sharp for a long time,only needs to be sharpened once in a few weeks
- The extended groove can withstand thousands of times of grinding, greatly improving the service life
Using UF-SHARP CBN grinding wheel helps you get the sharpest tools in the shortest time
GOOD GUY
Reviewed in the United States on September 20, 2024
It felt and looked sharp, but I couldn't cut with it. I have some really cheap lathe tools that cost less than $30. I used the gouge from that set to do my work. I have resharpened the gouge, but the angle must be wrong because it still doesn't cut.
Fish
Reviewed in the United States on July 1, 2024
This is a very well built gouge, sharp out of the box
drd
Reviewed in the United States on February 24, 2024
Out of the box the tool had a reasonable edge and cut well and after a few passes on a CBN Fine wheel the cut is very smooth and holding well through several small projects. I run the lathe area in a makerspace and wanted to try this tool to see how it performs. The first user of the tool was a second time turner and they found it very easy to balance yielding a smooth surface. Next up was myself roughing out an end grain block where it performed well. Third user was also a new turner who did roughing and general shaping with great results. All of these operations were accomplished without any need for further sharpening.
Doug'r
Reviewed in the United States on December 30, 2024
High quality, very sharp!
Leon Nelson
Reviewed in the United States on November 9, 2024
well worth the money.
Dick Henry
Reviewed in the United States on July 21, 2023
This HSS gouge performs exactly as it should
Scubadave
Reviewed in the United States on December 6, 2023
I am upgrading my lathe chisels and don't want to break the bank. Based on the 1" round nose scraper reviews, I purchased the 1" spindle roughing gouge. This is my first true spindle roughing gouge as I have been using a 1" carbon steel spindle gouge to rough turn my spindle blanks (lots of sharpening). The UF-Sharp gouge was well packaged in a plastic tube with foam at each end and in an Amazon cardboard box. Out of the tube, I have to say the handle was comfortable but the gouge did not appear to be very sharp resulting in a lot of chatter on harder woods such as Osage Orange and Peruvian rosewood. Due to the lack of sharpness out of the tube, I dinged the product by one star. I sharpened the gouge on a 6" pink Aluminum oxide wheel mounted on a Delta high speed grinder (had not received my 320 grit CBN wheel yet). After sharpening, the gouge cut much better. When my 320 grit CBN wheel arrived, I touched up the gouge but have not yet had the opportunity to see how sharp it is. Will report back after my next spindle turning project.
David
Reviewed in the United States on October 12, 2023
It’s a nice rougher, holds a edge for a long time.
Recommended Products