Your cart is empty.
Your cart is empty.
About Oil Suction Pump:
Rated Voltage: DC 12V
Rated Power: 60W
Maximum Pressure: 0.8Mpa
The Largest Flow: 5L/min
An Ideal for 12v Fluid Transfer Pump:
Widely used in general industrial equipment;
Small size, easy to carry and store;
Conveying low-concentration liquids, it is an ideal conversion pump for quick and clean oil changes;
Its working principle is to connect the clip to the 12V car battery, simple on/off switch power, 12v oil pump easy to use
12v Oil Pump Extractor Kit Package Included:
1 * 12v oil extractor pump
1 * 0.3" outlet pipe(inner diameter)
1 * 0.21" inlet pipe(inner diameter)
1 * 0.17" inlet pipe(inner diameter)
2 * clip
(Please allow slight error within reasonable range due to manual measurement)
Fluid Transfer Pump Kit, How to Use:
1. Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil
2. Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal
3. Open the filler cap, get dipstick out, force the tube into the bottom of the joint, until the tube does not move; then put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely); as no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.)
4. After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean
5. If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out
DAVID C. PALMER
Reviewed in the United States on February 26, 2025
I had to replace the discharge hose because it was so flimsy bent up, crushed nothing could pass through it when I received it from shipping. I had to buy a pick up hose longer and larger for my application. This was a tremendous extra expense to make it work have the cause of a new pump.
timothy
Reviewed in the United States on June 2, 2024
It is okay just a little smaller than thought it would be
Alecia W.
Reviewed in the United States on November 12, 2024
Very Cheaply Made! As Soon As I Opened The Box I Could Tell It Had Been Used Already Bc There Was Water Still In The Pump! Outlet Hose Does Not Tighten Down, So Will Have To Find a Male Fitting With a Nipple To Make It Work and Not Leak!! Buyer Beware!!!
roy phillips
Reviewed in the United States on June 18, 2023
This pump works OK if you want a gas tank and gas tank at the same level but it will not pick up pool more than about 2 feet that’s all the lift at house and barely that
Richard Byrd
Reviewed in the United States on March 19, 2023
It worked great for about 2 minutes and then it quit and ain't worked again the motor will run but it will not pump
Jeff M.
Reviewed in the United States on July 22, 2022
Needs longer pos/neg wire for ease of use. Also needs longer tubing for deeper dipstick travel away from motor.
way cool jr
Reviewed in the United States on June 25, 2022
This thing works great no mess changing the oil in the lawnmowers and I gets more 99% of all the oil out wish I came across this along time ago
Krish
Reviewed in the United States on October 21, 2022
The transfer pump is very disappointing. There is nothing good to say about the pump. The tubes are flimsy and curled easily. The transfer hose fitting was leaking as soon as you stated the pump. I could not tighten anymore to stop the leak. Other part is the pump is very slow and it took over 2 1/2 hours to pump 4 quarts from each engine. I wish I could have taken a photo to add, so everyone would have seen the mess it made in the bilge. Low suction power.
Recommended Products
$39.00
$ 20 .99 $20.99