Your cart is empty.
Your cart is empty.
The 1.5" TC bulkhead fittings are designed without welding.
The TC port can be added to any vessel without welding.
There is no flat surface for the wrench on the front of the flange.
The easiest way to fix the flange is to clamp any other with washers and clamps TC parts.
After tightening, you can insert a long rod or screwdriver into the hole of the wing nut
Customer
Reviewed in Canada on February 15, 2023
It only came with 1 o-ring, not 2 as described
Steve Thomas
Reviewed in the United States on October 1, 2023
Made my connections into steel pot easy and leak free.
Boomer
Reviewed in the United States on August 29, 2022
Great fitting. High build quality.
Woj
Reviewed in the United States on June 3, 2022
Works decent
Phillip Conner
Reviewed in the United States on July 22, 2021
Will buy again!
Jake
Reviewed in Canada on May 16, 2021
Just I ordered
T&RMB
Reviewed in the United States on February 4, 2021
Installed easily on my brew kettle. Drilled a 42mm hole clamped a 90 degree bend on the outside and tightened with a large crescent wrench. Leak free so far. the captured o ring design seems to work best for weldless fittings. Would buy again.
Paul F. Boniface
Reviewed in the United States on February 21, 2020
Worked great to make a new Port in lid of fermenter for transferring without oxygen.
dannib
Reviewed in the United States on February 14, 2020
Looks to be very well make and cut. Easy to install. Is work great to my electric brew setup!
Joe
Reviewed in the United States on September 26, 2019
I wanted to use sanitary triple-clamp connections where possible in my recent conversion of my home brewing gear from gas to electric. These are very well made, and have the perfect thickness and density gaskets to properly seal on the curved face of a brew kettle without leaking. For reference, I'm using 16 gallon, 16" diameter SS brew pots. I have no trouble fitting a 3500w Dernord heating element through the port. Just ordered another one for my HLT!
Recommended Products
