Your cart is empty.
Your cart is empty.Product Description
Product Description:
Lifters is to Transmit the Thrust of the Camshaft to the Push Rod (or Valve Stem) and to Withstand the Lateral Force Exerted by the Camshaft As It Rotates.The lifet is Equipped with an Adjustment Screw on Its Top to Adjust the Valve Clearance.
Product features:
Lifter is made of a special powdered metal iron alloy that is heat-treated for strength and wear resistance. In addition, contain a longer piston than conventional hydraulic lifters, which provides more load bearing surface and increases lifter longevity.
Mianly Functions:
If Your Car's Hydraulic Tappet with Issues of Abnormal Noise, Stuck, Excessively Excessive Wear on the Underside, the Check Valve is Not Tightly Closed, then This Hydraulic Valve Adjuster Product Will Be Your Best Choice to Solve These Problems.
Installation Note:
1. Use the Push Rod Seat of the Finger Gap Rod (the Regulator is a Plunger Ball Head) The Center Should Have a Sense of Solidity, and It Should Not Be Installed if There is a Feeling of Obvious Sinking into the Sink. 2. The Requirements for Cleanliness of Oil and Oil Flow Pressure Are More Stringent, There May Be Leakage in the Diaphragm Causing the Plug to Become Stuck. 3. If the Newly Replaced Hydraulic Tappet Makes Noise when the Engine is Started, Please Eliminate Noise According to the Following Steps; the Engine Runs at 2000~000r/min3 4 Minutes Now, then Idling for 30 Seconds, Repeat the Above if You Say Cycle, Repeat the Situation Need to Repeat Five or Six Times.