Your cart is empty.
Your cart is empty.ATV Axles for Front Driver and Passenger side, manufactured to give you quality and performance you can expect. The axles are QS 9000 and ISO 9002 certified made to OE quality standards. DTA ATV axle offers precision threads and splines to guarantee a proper fit and easy installation. Made with high quality steel center shaft, the premium grade neoprene boots have an excellent tolerance to resist high & low temperatures. Assembled with specially formulated moly grease to resist high temperature and reduce friction. Where applicable, new dust shields, ABS rings, and axle nut are included. The product is QS 9000 and ISO 9002 quality certified with 1 years / 12000 miles limited product warranty.
Kayla Leach
Reviewed in the United States on March 28, 2025
Fit our 2007 4x4 HPX Gator Perfectly, way cheaper than the dealer. As noted, the shafts are not painted, either spray with some sort of rust inhibitor or tape off and paint them. For us it’s a used and abused gator, not a show queen!
Linda Webb
Reviewed in the United States on January 6, 2025
Replaced failed axles on my 850d gator, the castle nuts are a different size make sure you save the old ones
nathan
Reviewed in the United States on March 17, 2024
For well, happy with product
knute
Reviewed in the United States on February 22, 2022
These fit as described for my 2007 Gator HPX. I could not use the provided shaft nut and washer, they were too shallow and oversized respectively. Including a cotter pin would have been nice. I had some on hand. Unlike the originals, the shafts were not painted or powder coated - which means they'll rust. Not biggies, but not 5 stars either.
Gary Kane
Reviewed in the United States on December 3, 2021
Very easy to put on, used on John Deere gator.
larry wright
Reviewed in the United States on August 31, 2020
If I would have known the CV being sold. Only came with 30 day warranty. I wouldn't have bought this crap. Mine only lasted out of warranty
CJ
Reviewed in the United States on May 10, 2020
Seem well built only reason gave 4 stars is because I had to send back first time I received wrong size. But they corrected the issue fast and everything worked out good. So I recommend this product for sure if your needing they are well built as said.
MarkO
Reviewed in the United States on December 24, 2019
Shipped fast and arrived in good condition. I put these on a 2007 Deere Gator HPX 4X4. It was a very simple and easy procedure - jacked up the Gator, put jack stands under the frame, took off the tires, removed the nut holding the shaft to the brake rotor, separated the ball joint, turned the steering wheel full right when on left (driver) side, slid shaft out of rotor, and used a tire spoon to pry CV shaft from the differential housing. Light grease on the new splines and reversed the procedure to put in the CV shaft.A few minor issues...No instructions and I couldn't tell the left shaft from the right shaft until I noticed that they were different sizes, the shaft for the left side is longer by about 2 inches. The castle nut supplied with the kit was too short so I reused the old nut. I wish there was a new cotter pin supplied with the assembly.
Recommended Products
$248.00
$ 99 .00 $99.00