Your cart is empty.
Your cart is empty.Product Description
Bluesman
Reviewed in the United States on February 4, 2025
I have a trailer jack that is obnoxious. It is long-winded and a complete pain to use. I've almost replaced it a few times except that it fits my trailer tongue well and it's sturdy.This adapter kit is wonderful! It was very easy to install. The old jack handle just needed to be removed by drilling out the factory pin. This installed in it's place. Everything needed is included in the kit. Whenever I use my trailer, I have tools with me anyway. I just make sure I have a cordless drill in the tool bag. Now I can deploy or retract the trailer jack in less than 20 seconds. Wonderful!!I wholeheartedly recommend this adapter kit. There is no downside to it at all. It just works well. Very easy to install and use. Great value, great seller, great quality, and fast shipping!!
David Ford
Reviewed in the United States on February 11, 2025
Only buy for utility trailers with minimal weight. Us d on a 6k loaded trailer and pin bent and broke quickly on first use.
titaniumrx
Reviewed in the United States on January 7, 2025
Initial impression was great - these pieces are machined out of billet stainless steel and polished. I only have one device with the 1" drilled jack shaft that this is meant to turn. I'm leaving the adapter and the bolt attached to the shaft because it's a bit of a nuisance to remove and reattach. Considering how good the overall quality of the parts are it's surprising that they didn't use a quick toolless attachment for the bolt. I am getting good use of the 1/4" hex to 1/2" square drive adapter for attaching sockets to my cordless drill.Overall, a great tool if you don't have to attach and detach frequently.
Debbie mccurry
Reviewed in the United States on January 23, 2025
Junk… put the screw gun to it and the little screw & bolt that comes with it bent. I was lucky to get it off the trailer in one piece. This must be for a little 5x8 trailer, bc it’s not strong enough for a real trailer.Don’t waste your time like I did…
My Product Review
Reviewed in the United States on January 20, 2025
I bought this to use with the jack on our cargo trailer-toy hauler conversion and it's working great.I like that it has multiple holes so that you can get the best possible fit.The holes are large enough to use a snap over type pin (i.e. type you get at hardware/farm equipment stores) with it but the hole in my jack isn't large enough for the snap over type pin so I had to stay with the bolt and nut that came with it.Note...I would have felt better about the purchase if the price would have been in the $16.95 - $17.95 price range.
Namaste
Reviewed in the United States on April 7, 2025
I got tired of stuffing blocks under my trailer jack or spinning the handle on the jack endlessly. The leveler works well for my two-ATV trailer. It has made lowering and raising the jackstand so much quicker. As long as I remember to bring my impact driver, I'm good to go, but just in case, I started carrying a smaller breaker bar in my trailer's tool box just in case I forget the drill or it runs out of battery.
Mr68K
Reviewed in the United States on December 5, 2024
These are not bad, but if I would have noticed the smaller one did not have a square drive I would have purchase the two single products instead of the 2 in one.the square drive should have a relief inside so it locks into your wrench.The included bolt is pretty weak, I did not trust it and used a grade 8 instead.
Brenda Powers
Reviewed in the United States on October 28, 2024
Better than described and a real labor saver! N
Recommended Products