Your cart is empty.
Your cart is empty.
Ø Package: Contains 2 struts and 4 ball studs, the size of the ball stud is 10 mm.
Ø Fit: Most suitable support weight is between 32-44 lbs per strut, please check your support cover weight before purchasing.
( Weighing Method: Please weigh the lid 20%-30% away from the hinge )
Ø Note: Couldn't be compressed by hands.
Ø Function: After installation, you can easily lift the lid using only the power of one finger.
Ø Tips: Under the premise that you can install it flexibly, if the force of the support cover is too strong to close, you can move the installation point to the direction of the hinge.
Alfredo garcia
Reviewed in the United States on March 4, 2025
Muy débil . Basura ( trash )
James E. Witt
Reviewed in the United States on February 14, 2025
Satisfied
A Botting
Reviewed in the United States on February 10, 2025
Worked perfectly for my old Subaru SVX hood.
Breakpoint Tech
Reviewed in the United States on January 12, 2025
Old struts on 2014 Keystone Raptor cargo door started to sag. Pulled off one of them, measured and ordered this one to replace. Popped it onto existing mounts in 30 seconds and was good to go. Plenty of lift strength and didn't even bother checking or swapping the second one, so saved the extra for future use. Good price, and totally satisfied.
Jason
Reviewed in the United States on August 4, 2024
Got these my Glastron boat engine cover. Unfortunately the 40lb struts (x2) barely enough to hold it open. That's my fault though for not double checking, but otherwise operate fine. Didn't use them but like that they included the ball joint hardware.
1dumfuk
Reviewed in the United States on December 13, 2024
It took three attempts to get the right size
Tam D
Reviewed in the United States on October 3, 2024
Replaced all of our side compartment shocks on our motorhome. Works great, easy to install.
Customer
Reviewed in the United States on October 21, 2024
Installed them on my Rowe Ami jukebox they work fine.
Recommended Products
