Your cart is empty.
Your cart is empty.
Lot of (200) torx drive flat head screws with a type F thread cutting tip.
These unplated screws are 5/16-18 thread and are 1-1/2" in length with a full length thread and T40 drive.
Steven
Reviewed in the United States on July 7, 2024
The media could not be loaded.
Tell It Like It Is
Reviewed in the United States on May 10, 2024
I used these to replace a partially rotted plywood floor in an enclosed cargo trailer. I sawed off the bad floor. HD now sells ground contact rated pressure treated plywood. I decided to go with that. I marked on the side walls in paint marker where the 2x2 angle irons were. I made sure all the old screws were removed. Then I cut the replacement plywood piece. I next used a M35 cobalt drill bit to drill the pilot holes. Then I drove these with a T-40 bit. These are quality screws.
Recommended Products
