Your cart is empty.
Your cart is empty.Installation Method ①Add grease to the inside of the gasket and grind off the angle of the pin a little. ② Put pin in a drill and bevel off the end of one side against a file or against some rough cement. ③ When installing on truck, put spacer in as well as insert pin in as far as it will go. ④ Use a hammer or C-clamp to drive the pin to the locking ring. ⑤If you have any installation problems, please contact us in time. 【Fitment】1/2 inch hammerlock connector can be used as safety chain kit for super duty truck such as Chevy Ford GMC. 【Material】Made of heavy-duty G80 alloy. Each link provides a load capacity of 12,000 pounds.
Customer
Reviewed in the United States on February 3, 2025
Works as expected based on the description on Amazon. It is much easier to connect my travel trailer. Installed trailer hit hitch on truck made it difficult to connect my chains and remove them.
Nick
Reviewed in the United States on January 2, 2024
Our Ford trucks have a set up that doesn't work well with the trailer chains. I installed a set of these in the receiver and now hook up is a breeze. Installation was easy!
Carlos G.
Reviewed in the United States on December 24, 2023
Second set, first set didt set in right with the hammering. Sent back and seen a comment about using grease and a C-clamp. Went in So much better!!!
Christian Touchais
Reviewed in Canada on November 8, 2023
Paint is not strong but the rest is OK
Gerald Gilbert
Reviewed in the United States on October 23, 2023
The '19 Ford Super Duty hitch doesn't accommodate RV safety chain shackles like my 2011 did. So I bought this thinking it would work - but cheap Chinese steel apparently has to be larger diameter to get the same strength as a USA made by Crosby. Just by a Crosby bow shackles and keep rolling!
Preston
Reviewed in the United States on June 9, 2022
These look great on my 2017 f250 got each one on with under 10 hits with a 3lb hammer, some grease and some leverage
Lawrence Goulet
Reviewed in Canada on May 29, 2022
Perfect for my towing needs
Makinsey Campbell
Reviewed in the United States on March 16, 2022
Took about 2 minutes to install both. Started with a C-clamp, hit the end of the clamp with my hammer then just continued to hit it while holding with my hand and went right in. Trailer chains hook right to them.
Customer
Reviewed in Canada on December 8, 2022
After using clevices due to a poor chain connection point on the hitch, this is way better and can’t be stolen. Easy to connect to with tow chain hook and good value.
hollandbr2
Reviewed in the United States on September 17, 2021
Fits the chain lobes perfectly on the Draw-Tite Ultra Frame Trailer Hitch Class V, 2 in. Receiver, PART # 41948 that I just put on my truck. Fits chain hooks easily now. Look good also for hook/shackles.For installation, don’t even try to hold the assembly and hammer the pin. That is just silly. However with a large 12” c-clamp and greasing the pin, once you get it lined up and started, it’s quick easy work.
Customer
Reviewed in the United States on November 21, 2021
These shackles solved a problem that Ford could have solved. So easy now to connect my trailers.
Recommended Products
