Your cart is empty.
Your cart is empty. Key Features:
304 stainless steel material
Rust and wear resistant
Durable and heavy duty
Advanced internal spline
CNC machined
Specification:
Material: Stainless Steel
Universal Joint Diameter: 10mm
Shaft Body Diameter: 8mm
Hole size: 4mm
Package Included:
2* RC Drive Shaft
JC
Reviewed in the United States on May 27, 2024
Splines had a rough finish but I was able to clean them up with lapping compound.
wolfman
Reviewed in the United States on December 12, 2024
They are just good. No issues installing it. Have ran it for a few hours in rocks, snow and so on. Used a little bit of super lube so it slides in itself better. Would reccomend.
Russ
Reviewed in the United States on December 12, 2023
Packaging was pretty good for the product. The larger of the axle shafts still has metal burrs in both ends from threading the holes where the pins go to hold it to the RC car. The smaller axle shaft had some rough machining on the splines that made it not operate smoothly which is the main reason I returned the product. Another small annoyance is that when they machined the splines into the smaller axle shaft they were slightly out of phase so you couldn’t orient the u joints perfectly. Last pice of information to know is you want to use this on an axial utb18 you will have to remove the small washer from the stock pinion shaft on the axle or this won’t go far enough on to install the treaded pin that holds it on.
nick shivener
Reviewed in the United States on November 8, 2023
I have 3 different brands of 1/18 scale crawlers and these do not come close to fitting any of them.
F. Williams, Jr.
Reviewed in the United States on January 29, 2023
Purchased these for My Axial UTB 18 Capra (Fox 1/18 scale.) Great fit, upgrade and weight. Install was easy, but instructions not included. I would recommend this product and/ or purchase it again.
Recommended Products
$26.98
$ 13 .99 $13.99