Bob H
Reviewed in the United States on February 10, 2025
As promised
Terry Champion
Reviewed in Canada on August 16, 2024
Lights are no good, a line with no light straight through the middle horizontally. Shines on the road for 30 feet and in the trees
Drew
Reviewed in the United States on October 6, 2024
Had to use electrical tape to keep from moving but work great so far!
Tyler James Keeble
Reviewed in the United States on March 17, 2023
These lights look and work great. Easy to install and very fair price.
!!!!! C5 !!!!!
Reviewed in the United States on January 24, 2023
Admittedly, I don't drive a lot after dark. These lights look fantastic along with the LED headlight unit. Very visible from a long way off. What little I did ride after dark these performed as good as or better than the factory halogen lights but were much whiter. From a safety perspective I think the whiter LED is more visible to oncoming drivers. I can recommend these and would buy them again.
J L Scott
Reviewed in the United States on October 19, 2022
Had to do a little wiring/connector work and wrestling with the trim visors. All n all pretty straight forward install. Quit a difference from the old bulbs. They look like small suns as opposed to 2 fireflies screwing. The blackout matches up with my led headlight perfect.
Customer
Reviewed in the United States on August 20, 2020
Installed these lamps on my 2012 Harley Davidson FLD with added passing lamp mounts. The install was fairly simple with just a couple of spade fittings being added to the lamp wiring. After I ride with them for a while I will most likely remove the spade connections and solder the pigtail wires to the stock wiring harness. I have not been able to ride at night yet from the test I did in my drive way the lamps will be as bright if not brighter then the lamps I replaced. Will come back and add to this review after I put some miles on the lamps.
USA1
Reviewed in the United States on June 5, 2018
The LED driving lamps fit perfectly in my Harley Davidson buckets. All I had to do was cut off the stock connectors, strip four wires, put on shrink wrap tubing, solder the wires together and heat up the shrink wrap. Very good brightness with a much lower amp draw for all the lights to be on. At this price point, the high watt halogens don't even come close to the light output of these LED driving lamps. I can now ride with a little more confidence on the dark two lanes without wondering if I will see that deer on the side of the road.
Christopher Poorker
Reviewed in the United States on April 1, 2018
The lights are very easy to install. The red wire is hot and the black is negative/ground. I used these in a set of headlights that doesn’t have a negative running to the battery. Instead it has a ground that screws to the passsing light housing. It worked with no problem. Easy to fit into my light bezel as well. The light comes with a plug end to attatch to your current wires if you need it and the other end of the plug comes out on a wire about 6 inches from the light. Both sides of the plug are identical. When I plugged my second one in there was no power, so I turned it around and EUREKA there was power. I soldered the plug end that came with it to my cycle wires and from now on it will be as simple as plug and play if I ever have to replace the lights.