Shopping Cart

Your cart is empty.

Your cart is empty.

4pcs BTS7960 43A Dual H-Bridge Stepper Motor Drive Current Limit Control Semiconductor Refrigeration PWM for Smart Car Motor Drive Arduino

5.0 Write Review
Free shipping on orders over $29.99

$21.99

$ 8 .99 $8.99

In Stock

About this item

  • 5V isolate with MCU, and effectively protect MCU; 5V power indicator on board.
  • Voltage indication of motor driver output end; can solder heat sink.
  • Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2); isolation chip 5 V power supply (can share with MCU 5 V).
  • Able to reverse the motor forward, two PWM input frequency up to 25kHZ; two heat flow passing through an error signal output.
  • Isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply; the supply voltage 5.5V to 27V.


Instruction:

This driver uses Infineon chips BTS7960 composed of high-power drive full H-bridge driver module with thermal over-current protection. Double BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver! High-current 43A.

Electrical performance:

Model: IBT-2

Input voltage: 6V-27V

Maximum current: 43A

Input level: 3.3-5V

Control method: PWM or level

Duty cycle: 0-100%

Input port:

1.RPWM: forward level or PWM signal input, active high

2.LPWM: Reverse level or PWM signal input, active high

3.R_EN: forward drive enable input, high-level enable, low level off

4.L_EN: Reverse drive enable input, high-level enable, low level off

5.R_IS: forward drive current alarm output

6.L_IS: Reverse drive current alarm output

7.VCC: +5 V power output, 5V power supply connection with the microcontroller

8.GND: signal common low end

Package Included:

4 * BTS7960 43A High Power Motor Driver Module/ Smart Car Driver Module