Your cart is empty.
Your cart is empty.Single end 4 flute center cut end mill ground from solid high speed steel. Used for removing material from a workpiece and leaving a smooth finish. The 4 flute design allows for a high feed rate as less material is removed per flute. If greater swarf removal is desired, consider one of our 2 flute end mills.
David
Reviewed in the United States on April 7, 2025
center cutting and sharp!
mike
Reviewed in the United States on April 14, 2025
as indicated
berrypatch101
Reviewed in the United States on June 3, 2024
Needed it for a specialty job and it worked well. Didn't loose it edge prematurely as some cheap tooling does.
RANDALL M.
Reviewed in the United States on January 8, 2024
Ready to use!
KS Consumer
Reviewed in the United States on August 25, 2021
This has cut my surfacing time in half on my benchtop mill. Great tool!
Hairbrainer
Reviewed in the United States on December 30, 2019
Used to remove material from a 1965 Norton clutch basket hub to improve the seating surface of the tensioning bolts.
Recommended Products
