Your cart is empty.
Your cart is empty.Product Description
12mm (1/2") Metal Push Button Switch
Shell Material: Nickel plated brass
Head Shape: Raised head
Operation Type: Momentary
LED Rating: 3A,12V-24V DC/AC
Led Pattern: Halo Ring
Contact Configuration: 1NO
QTY of Terminals: 4 pins
Contact Material: Silver Alloy
Mounting Hole Size: 12mm (1/2")
Protection Degree: IP66,IK09
Package Content: 5*Switch
IP66
- The shell is full metal and there's a rubber ring to seal the mounting which make the switch achieve IP66 Waterproof degree.
- It can be used in humid environment, such as boat, kitchen, outdoor etc.
Long Work Life
- The metal shell and push part is not easy to damage.
- The Mechanical work Life is 500,000 cycles.
- The Silver Alloy contact makes the Electrical Work Life more than 100,000 times.
High Quality LED & 5 Colors
- The LED light is pure and bright.
- There are 5 colors for your choice: green, blue, orange, red and white.
- LED Life: 40, 000 hours.
Wide Application
Worked Once
Reviewed in the United States on February 25, 2025
good quality otherwise.
Janet Sullivan
Reviewed in the United States on January 6, 2025
Overall, a good buy. They look great and 1-Day delivery.Cons: When soldering, the pins will detach if you don't do a speedy solder job. - Also, you'll need an electron microscope to read the pin designations on the back... I had to figure it out by trial and error, I couldn't read +, -, nor input/outputBut - they're good - look great!
Frazier
Reviewed in the United States on January 1, 2025
I set this up to have the light always on if the power is on. It is used for an air horn on my golf cart. Silly I know, but fun. Easy to hide and works as expected.
TLing
Reviewed in the United States on September 10, 2024
The only thing that would improve this a little is the makings on the switch for the light and the switch easier to read. Once you read the small writing the switches were easy to wire and a nice bright light.
adrian
Reviewed in Canada on July 7, 2024
I bought these push button power switches to replace a broken push button switch on my 1968 sansui. Very easy to install on vintage gear cause there's no positive or negative wires so it doesn't matter which way around you join wires together.
Gram3
Reviewed in Canada on May 19, 2024
14volts going in and 11.5volts coming out. 3 out of 5 all tested the same. 1 star because they look nice.
Robert L Flegal Jr
Reviewed in the United States on March 25, 2024
Used for a momentary switch on my zero turn's handle. Press and activate power via relay to the sprayer in tow. fit the end of the lever well and functioned perfectly.
Ph
Reviewed in the United States on January 5, 2024
Extremely well made. Has two ways to wire the light on the switch. You can have the light always on or light up when switch is activated.
Wambat King
Reviewed in the United States on April 20, 2024
Purchased these for a small lighting project and they worked perfectly.
burnem79
Reviewed in the United States on August 2, 2023
I have 3 of these connected to an Arduino board to activate different functions. I ordered these and had them in my hand when I realized they were 12-24 volts. No big deal if you're using them with automotive application but the arduino only puts out 5VDC. Fear not, the LEDs light up quite nicely with only 5V being supplied to them, enough you can see them in a lit room. These push smooth and of all the times I have used them, they have never missed a press. I will buy more of these when the time comes.
Recommended Products