Your cart is empty.
Your cart is empty.
Technical Specifications :
Connector Width : for 6x12 mm led neon strip
Cable length: About 7 inch / 180mm
Compatible Any SMD 2835 LED Neon Strips Light
Installation Instructions:
1. Ensure your section of LED light strip has two contacts (+ and -) and the contacts are both clean
2. Open the white clasp of the connector
3. Insert the LED light strip into the clasp, under the prongs - making sure to match the + and - on the strip to the + and - on the clasp
4. Close the clasp
5. Gently pull on the LED light strip to confirm you've made a solid connection
6. Your connection is made! (This product is used only to conductive connection, want to fixed please to solder. )
KenK
Reviewed in the United States on February 10, 2025
Make sure that the pins are lined up with the copper connection points and snap shut. Good connection made easily.
Rachel555
Reviewed in the United States on May 16, 2024
I didn't want to learn how to solder just for this project so these were wonderful. They worked and did the job so I am thrilled.
mason
Reviewed in the United States on February 7, 2024
With some focus and attention to detail, you will see which direction these go and how far the pins need to go through the LED strip to reach the contacts. This won't work if you don't touch the contacts...
Court fam
Reviewed in the United States on November 15, 2024
These are terrible, they are unreliable and break easily. I recommend soldering like I ended up doing. Solder and silicone all open ends if outside.
Recommended Products
$11.27
$ 5 .99 $5.99