Your cart is empty.
Your cart is empty.Product Description
Installation steps and precautions
Remove the old clutch
1. Locate the compressor:
- Open the engine compartment and locate the A/C compressor (usually located on the right side of the engine, belt driven).
- Clean the compressor surface of dust and make sure the operation area is clean.
2. Remove the belt:
- Loosen the belt tensioner with a wrench and remove the drive belt from the compressor pulley.
3.Remove clutch front cover:
- Remove the clutch front cover retaining screws using a 10mm socket.
- Gently remove the front cover to expose the internal clutch and coil.
4. Remove the clutch assembly:
- Use the puller to secure the clutch center shaft, turn the puller screw counterclockwise and slowly pull out the clutch disc and bearing.
- CAUTION: Avoid forced prying to prevent damage to the compressor shaft.
5. Remove solenoid coil:
- Disconnect the coil power plug.
- Use a screwdriver to remove the coil fixing screws and take out the old coil.
Install new clutch kit
1. Clean contact surfaces:
- Clean the compressor shaft and clutch mounting surface with a non-woven cloth to remove oil and rust.
2. Install new solenoid coil:
- Align the new coil with the mounting holes, fix the screws and tighten (torque: 8-10 N-m).
- Reconnect the power plug.
3. Install the bearing and clutch disk:
- Apply a small amount of high temperature grease to the compressor shaft.
- Align the new bearing and clutch disk with the shaft holes and tap them with a special tool or rubber mallet until they are fully seated.
4.Install pulley and front cover:
- Install the pulley back and make sure that it rotates smoothly and without jamming.
- Fix the front cover screws (torque: 10-12 N-m).
Material Process
High carbon steel solenoid coil + heat treated bearings, high temperature and wear resistant, 50% longer life
Strict Testing
Passed 100,000 times start-stop cycle test to ensure long-term stable operation
DIY friendly
Comes with detailed installation steps + tool list, replacement can be done in 2 hours
Compatible with car interface
No need to cut or weld, directly replace the damaged parts
Complete accessories
Comes with everything you need for installation and gaskets, comes with large snap ring, small snap ring and screws, etc., stays the same as the picture shows
Cost Savings
The price is only 60% of the original parts, eliminating the high labor cost of 4S stores
$14.82
$ 7 .99 $7.99
$125.99
$ 58 .99 $58.99
$39.97
$ 16 .99 $16.99
$59.95
$ 29 .99 $29.99