Your cart is empty.
Your cart is empty.
- This automotive carpet will be made in 801-Black Plush Cut Pile. Other colors and materials may be available in the selection above.
- This carpet is a replacement for 1986 to 1992 Jeep Comanche Truck, Regular Cab. This item is for a regular cab truck and carpet covers the whole floor.
- Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
- Unless specified, the jute padding will be attached in the foot area of the carpet
- Installation may require trimming around the edges and the holes may need to be cut.
- There is a large variety of colors available. Please request free samples if you want to match a specific color
- This item fits the years: 1986, 1987, 1988, 1989, 1990, 1991, 1992, 86, 87, 88, 89, 90, 91, 92
READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets
1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. It may be necessary to use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.
Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.
Joshua P Hicks
Reviewed in the United States on February 19, 2021
Quality of product is good, nice carpet. However, fitment is atrocious. I've been restoring and modifying vehicles for 25 years and this is one of the worst if not the worst fitting carpet kit I've ever used. Definitely wouldn't recommend.
Dylan
Reviewed in the United States on July 26, 2020
Color was an exact match of the sample piece and there’s lots of excess which makes for a perfect fit if you cut it right. It’s a little thin but I added padding / sound deadener so wasn’t too worried about it.Only downside is cot came rolled up tightly in a box which left some gnarly creases that are near impossible to get out, tried a heat gun, a steamer, and letting it sit in the sun with no luck. It also pops around and won’t sit flat and “molded” on its own so some tape and glue were necessary.However if you take your time and work with it, you’ll get a great result.
John Jurgenson
Reviewed in the United States on August 31, 2019
Kinda thin, but fit very good.
Customer
Reviewed in the United States on December 23, 2017
Fit perfectly on 1989 Jeep comanche
Recommended Products
$134.99
$ 65 .99 $65.99