Your cart is empty.
Your cart is empty.
- This automotive carpet will be made in 8078-Dark Grey Plush Cut Pile. Other colors and materials may be available in the selection above.
- This carpet is a replacement for 1998 to 2011 Ford Ranger Extended Cab Pickup Truck. This item fits extended cab, 2 and 4 wheel drive trucks.
- Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
- Unless specified, the jute padding will be attached in the foot area of the carpet
- Installation may require trimming around the edges and the holes may need to be cut.
- There is a large variety of colors available. Please request free samples if you want to match a specific color
- This item fits the years: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 98, 99, 00, 01, 02, 03, 04, 05, 06, 07, 08, 09, 10, 11
READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets
1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. Use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue for remainder of installation, working to outer edges
8. Once carpet is properly fitted, do the final trim on outer edges, seat belts, holes, etc
Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.
leonard archuleta
Reviewed in the United States on May 4, 2024
Could’ve been trimmed down a little bit more, but looks good in the truck
Customer
Reviewed in the United States on July 15, 2023
It was the easy to install was perfect in every way
Trout chaser
Reviewed in the United States on June 5, 2022
The picture posted on the carpet leads you to believe that the carpet is premolded but in fact it is not. Flat piece of carpet with the various padded areas on the under side.
A. Hinkle
Reviewed in the United States on January 8, 2022
This carpet wasn’t even remotely molded properly. My problem is that I was installing it in a standard so it had to be cut to even see if it fit properly and after cutting the gear shift hole, it didn’t fit at all. I didn’t even attempt to try and return because it would be a fight because it was cut. DONT BUY THIS CARPET.
Cody
Reviewed in the United States on November 30, 2021
Came very wrinkled like they described. Lay out in the sun for a few hours and it will flatten out. I had to trim all 4 sides. Take your time trimming. And cut little bits at a time. Came out very nice!
Mary O.
Reviewed in the United States on October 21, 2020
The product is for the most part easy to install. Id focus on matching the driver side up with the built in mat. I couldnt get mine even so kind of bummed about it but will use floor mat to cover it anyway.WARNING. CUT HOLES AND BOLT SEATS IN. If you cut your edges before this it will pull when the bolts are mounted down and cause a shortage on the edges of your carpet showing the metal floor!! I had to use extra left over and make a patch. Nice flooring though if installed properly!
Recommended Products
