Your cart is empty.
Your cart is empty.ACDelco GM Original Equipment Hazard Warning and Turn Signal Flasher is a GM-recommended replacement component for one or more of the following vehicle systems: body-electrical and lighting. This original equipment flasher will provide the same performance, durability, and service life you expect from General Motors.
Lorena
Reviewed in the United States on March 22, 2025
Worked on my 2002 Chevy Trailblazer.
john n kuzmich
Reviewed in the United States on February 25, 2025
Genuine GM OEM, part assembled in USA 🇺🇸 solved my problem. Original part was Trico, this is a direct replacement.
James
Reviewed in the United States on September 7, 2024
The right turn signal in my 07 trailblazer hasn’t worked in about a decade other than maybe 3 blinks per month and this part fixed it. Super easy installation just take the panel above the pedals off, easy swap
Kbar
Reviewed in the United States on October 20, 2024
Fixed our issue and works perfect.
Nick
Reviewed in the United States on October 11, 2024
Customer had an issue with the directional not always working. Originally he wanted a new turn signal stalk however after looking into it more it made more sense the relay would be the issue. Replaced the relay in under 5 minutes on a 2006 Envoy and all was back up and working as it should.
Uncle B
Reviewed in the United States on December 20, 2023
Solved my left turn signal issue on my Trailblazer. Very little removal of interior trim to access the unit, just 2 screws on either side of the steering column. Getting the actual existing flasher removed can be tricky, but if you use a 'pick tool' to help release the pins holding the flasher in place, especially on the harder to reach back side, you will have an easier time removing the 'bad' one. Good luck.
Lorne Bragg
Reviewed in the United States on January 28, 2023
replaced and it works fine presently will see how well it lasts
Jasper
Reviewed in the United States on March 24, 2016
My left blinker only worked one out of 10 times when I pushed the blinker switch. The right blinker worked perfectly all the time. When my left blinker was not working, if I turned on the hazard lights, only the right side blinked. When the left blinker was working, if I turned on the hazard lights, both sides worked.Did some research and found out the most likely problem was a defective turn signal flasher. The previous owner had replaced the entire blinker switch a few weeks before I purchased the vehicle thinking that was the problem, but it was not.I got this new turn signal flasher and now everything works perfectly....every time !Simple install. On my 2007 Trailblazer, there are two screws holding the plastic strip down where the drivers feet are. Remove the screw at each end, finesse the entire plate down a bit, look for the signal flasher which will be half inside another plastic piece, hold the clip to allow the flasher to be removed, install the new one and put everything back together. Pretty easy overall !
Recommended Products
