Your cart is empty.
Your cart is empty.An ACDelco GM Original Equipment Engine Camshaft Position Sensor monitors the rotational position of the camshaft(s), and is a GM-recommended replacement for your vehicle’s original component. It provides a signal to the engine control module, which compares the camshaft position with the crankshaft position to determine ignition and fuel injection timing. This original equipment engine camshaft position sensor has been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.
Mauricio Hernandez
Reviewed in Mexico on August 6, 2024
excelente servicio
G H
Reviewed in the United States on July 25, 2024
Perfect match if you are looking to replace the camshaft position sensor. (2018 Traverse)
Oscar
Reviewed in Mexico on July 25, 2024
Aun no lo instalo, tengo duda que sea original
Customer
Reviewed in the United States on June 30, 2024
I bought an aftermarket and my car was leaking then I bought this one and it fit as it should, good product.
Bradley A. Seber
Reviewed in the United States on May 23, 2024
Fit good , worked
Matt Brook
Reviewed in the United States on May 1, 2024
Had an engine code on my 2010 Malibu for camshaft position error. This was a direct replacement and cleared the code immediately. It's been 6 months and no problems!
Feel better 😌
Reviewed in the United States on December 9, 2024
Fit right in old 1,s place
Jo
Reviewed in the United States on December 11, 2024
Perfect part
Antonio Vázquez Rodríguez
Reviewed in Mexico on June 20, 2022
Todo bien y llego antes del tiempo de entrga
Alessandra Lambertini
Reviewed in Mexico on April 12, 2022
Le quedó a mi Captiva Sport 2013 4 cilindros, la luz de check engine no se fue porque al parecer necesita reemplazo de dos sensores iguales a este, no solo de uno.
Cam- South Dakota
Reviewed in the United States on July 21, 2020
Did the trick. Works like it should.
Lauri Olin
Reviewed in the United States on August 23, 2019
Usually these are very easy to install but the thing you should keep in mind as magnetically balance Motors use full synthetic oil and if you're not using full synthetic it's probably the oil not your sensor replace the oil is full synthetic and then I think you might be surprised but it's not the sensors but if you are already using full synthetic senso oil and you are still receiving codes then most likely it is the sensor needing to be replaced it is not a myth conventional oil cannot be used on magnetic balanced Motors especially Ecotech
Recommended Products
