Your cart is empty.
Your cart is empty.Heavy-duty aluminum die cast pump dispenses 1 gallon in 5 strokes and includes 2" die cast bung adapter, extra heavy-duty steel handle with security locking latch, and telescopic suction tube adjustable to fit 15-55 gallon drums. Dispenses easily through 8' of anti-static neoprene rubber hose with die cast dispensing nozzle.
Kim
Reviewed in the United States on December 29, 2019
A cheap piece of junk, don't buy!!!
roddo13
Reviewed in the United States on September 28, 2018
1 Gallon only Takes 5 pumps. Time saver !
Dennis Mccormack
Reviewed in the United States on July 25, 2015
one of the few that worked from the outset. others needed priming and then that didn't always work. I highly recommend this pump for diesel or gas.
artschuerg
Reviewed in the United States on October 9, 2015
really like it had a cracked housing am returning it leaked all over
R S L
Reviewed in the United States on November 26, 2013
great product, works wirh ease and is very well made. Moves a lot of gas in a hurry, a must have in a shop
Paul Boling
Reviewed in the United States on June 2, 2012
Works great thanks to the adjustable shaft that adjusts to the depth of tank. Need an adapter hose end however so that the nozzle goes inside the flap on a car gas tank. Good shipping as always with Amazon.
Steven Whitman
Reviewed in the United States on February 27, 2011
I have fueled my equipment with rotary pumps in the past and have had to prime them each time. This diaphragm pump works great without that hassle. The quality of the pump is very good and at a reasonable price.
Angry When Lied To
Reviewed in the United States on December 31, 2011
This is a fast pump but there is a small leak that results in some fuel dripping out of the bottom of the housing and pooling on the barrel top. Not a problem until you have to move the barrel but then it is a mess.June 12, 2013 Update - the hose requires careful attention, it is a straight connection to a fitting perpendicular to the lift tube after about a year and a half hanging as shown in the picture, the hose cracked and failed. I added a 45 degree fitting to the pump head to take the strain off the replacement hose and I'm careful to coil it on the barrel top to relieve strain.
Recommended Products
