Your cart is empty.
Your cart is empty.Product Description
Akona Fast-Setting Anchoring Epoxy
Fast-Setting Anchoring Epoxy is a two-component, high-performance, 100% solids, high-non-sag gel epoxy designed for anchoring bolts, railings, dowels, and rebar steel into concrete and to bond or repair a variety of household and common building materials including concrete, porous tile, and stone.
Easy to use!
Prepare the area...
Prepare your application area to fit your project.
Caulk & dispense...
Dispense a bead of epoxy until the color is uniform. This is done to remove air and ensure the correct mixing ratio, this material must be discarded.
Apply...
Dispense the epoxy into the anchoring hole filling from the bottom up. The annular space around the bolt, dowel or anchor should not exceed ⅛ in.
Let Dry!
Initial cure in 2 hours. Reaches final cure in 12-16 hours. Allow to cure until the epoxy is hard to the touch.
Craig Lamach
Reviewed in the United States on July 5, 2024
I love this stuff. Started using it as crack filler 10/10
Customer
Reviewed in the United States on July 4, 2024
sets nice and fast
Mathew
Reviewed in the United States on July 16, 2024
The epoxy worked ok. What I did not like is the tube is only about 1/2 full. I ran out when I thought I had 1/2 left. That said some other key points: Expect to use whole tube in one shot. Nozzle is not designed to be cleanable. The product explicitly says not for tension loads. Do not expect an entry level caulking gun to work easily with this product it is slightly thicker.. Compare to the actual professional product I bought locally at the supply house this was substandard for concrete anchoring. (The other product was guaranteed for tension and had numbers and thorough instructions) The epoxy did not seem to bind to the anchor bolts themselves... So I have doubts. Would not use anywhere but low risk applications. The "solids" which I think provide higher shear strength seemed exceptionally low compared to the commercial products I have used. This is a do not buy again simply for the 1/2 filled tube and non-cleanable mixing spout. (it can be done... with patience, acetone, luck and time)
Marshal Shlafer
Reviewed in the United States on February 24, 2024
Used the product to epoxy some bolts into two holes in concrete. Kept the tube warm (it was cold/cool outside) per instructions on the tube. It set up well, I could get *almost* all the epoxy I needed to fill my holes out of the tube... almost. Both parts of the epoxy are very thick, which is normal.The long dispensing tube/nozzle that helps you squirt properly mixed epoxy deep into a hole has a honeycomb arrangement inside that mixes the 2 parts nicely, but the epoxy starts setting up so quickly that after getting only about 1/4 of the material out of the tube it became basically impossible for me to squeeze the "trigger" on the caulking gun hard enough to keep the stuff flowing. I had to take the mixing tube/nozzle part off, squeeze expoxy onto a piece of cardboard, mix it by hand, and try to get it into the unfilled part of my concrete holes quick enough to do the job. Messy, and basically unacceptable.So this stuff worked for me. Sort of. I hope. But if I had more than two holes to fill the product would be totally unsuitable because I wouldn't be able to get enough out in time, before it set up in the dispensing nozzle, to do the job.
Gregory Mathews
Reviewed in the United States on December 27, 2024
I have used this epoxy to replace ceramic floor tile and wall tile and it holds up very well and drives very quickly
mouse
Reviewed in the United States on April 17, 2024
will work as adhesive also, in a pinch, only adhesive I had set ceiling tiles with it and also used left over on plastic bed rails that had come loose on my GMC truck. sets up fast , should buy extra mixing tubes.
Shad B.
Reviewed in the United States on August 19, 2023
Both of the orders were unacceptable. First one did not have the nozzle and the second one the nozzle was broken
JB
Reviewed in the United States on February 26, 2023
I had to install two anchor bolts in masonry wall ttWorked perfect quick and easyHad to bend Front part of caulking gun to fit the tube inMinor adjustment may not be needed on other guns
Recommended Products
$16.06
$ 6 .99 $6.99
$25.92
$ 12 .99 $12.99
$47.95
$ 22 .99 $22.99