Your cart is empty.
Your cart is empty.Product Description
Amarine Made Automatic Submersible Boat Bilge Water Pump 12v 760gph Auto with Float Switch-New
Product Feature
*Compact, efficient, long life motor
*Rustproof and corrosion resistant
*Stainless steel shaft
*High-impact durable plastic housing
*Quick release strainer for easy maintenance
*Extremely efficient, very low current
*draw and offer high capacity output
*Water cooled long-life motors
You don‘t need separate float switch
*No separate float switch is needed
*Equipped with built in electronic controlled reed sensor system for easy fully automatic operation
*No power use until pump is activated by internal float switch (when water level rises)
Product Performance
*Silent and vibrationless operation
*Anti-airlock protection
*Will not burn out when run dry
Integrated float switch TEST button at rear of unit
*Can be used with switch panel for manual override
Package Contains
*You can use with switch panel for manual override
*Includes comprehensive user manual with installation instructions and wiring diagram
Product details
Amarine-made automatic bilge pump -760gph
Rustproof and corrosion resistant Stainless steel shaft
High-impact durable plastic housing
Quick release strainer for easy maintenance
Extremely efficient, very low current draw and offer high capacity output
Water cooled long-life motors
Ignition protection to protect the pump against high current
Water/moisture tight seals
Silent and vibrationless operation
Mike Mascow
Reviewed in the United States on September 10, 2024
Does a great job keeping water out of our pontoons. Works on automatic setting! Turns on and off all on its own. Love it.
Commodore Keith
Reviewed in the United States on June 3, 2024
The media could not be loaded.
charlotte garner
Reviewed in the United States on April 25, 2024
The float get stuck and will not auto come on. The slave shaft ses to deteriorate over time and causes the float not to move up. They could re design the shaft to fix the problem. But if you are relying on it to auto pump water out, the boat will sink or destroy your inboard motor
Stephen R. Hei
Reviewed in the United States on March 21, 2022
The media could not be loaded.
Patrick Broomell
Reviewed in the United States on October 6, 2022
I have an I/o 19 ft boat with limited room the lowest bilge area, where this needs to be mounted. They only way to complete the task is mount it on a board and glue it to the boat floor. Drilling new holes in fiberglass is not advisable. The only way I can see it can be done is to glue it with 5200 adhesive. Try drilling under a motor in a bilge. Virtually nightmarish and more likely dangerous to do. Go too deep the bottom weakens. I can see not other simple way to accomplish this install. So! I have to give it a fail. Kind of disappointing!
R0bert Hudock
Reviewed in the United States on September 15, 2021
Its a BILGE pump for my 22 foot Deck boat no problem installing this product as long as you follow the instructions it works very good
Nic4nier
Reviewed in Canada on August 3, 2021
Je l’ai prise pour remplacer ma pompe de douche dans mon bateau et elle fonctionne no 1
J. H. Lewis
Reviewed in the United States on June 18, 2019
This unit pumps water...works extremely well so far. Have yet to install the proper 3way switch.Remember..no power no pumping. So if installed because your exposed to rain be sure of direct connection
chicagodiver
Reviewed in the United States on June 8, 2017
Works well on both auto and maunal, pumps grate (blue portion) is easy to remove from body. Sometimes debris does get caught in impeller so you have to pull the pump off and clean out the debris. All bildge pumps are that way, however ive seen others with same grate but has secondary stainless screen to protect the impeller... so this should get 4 stars but if you compare the price difference, i decided to give it 5 stars. But be prepared to clean the pump from time to time. Mine is mounted on a 17ft boston whaler, so even if it failed, i trust the boat will stay afloat😊
Recommended Products