Your cart is empty.
Your cart is empty.Derek Lynch
Reviewed in the United States on August 25, 2024
Sensor causing engine to surge, do to faulty part.
Guy D.
Reviewed in Canada on July 23, 2023
Working as intended
S. Mitchell
Reviewed in the United States on January 13, 2023
It caused my 4runner to surge up and down in RPMs
Angelo Calamusa
Reviewed in the United States on December 23, 2022
The media could not be loaded.
Valentine
Reviewed in the United States on October 10, 2021
Haven’t had a problem yet. 2 months in and CEL is gone on my 02 4RunnerUpdate a few months later: CEL IS BACK
J.
Reviewed in the United States on November 25, 2020
This is actually two pieces; a threaded sensor and a bracket with two holes that fit my 4Runner . More honest photos would have show the two pieces . One should be very careful to fully tighten the sensor into the bracket as the extreme heat and then cooling of the exhaust in that location might tend to cause the fit to loosen . A one piece sensor is what your original was and also what I would’ve preferred to buy . It did cause the CEL light to go out after disconnecting the battery for several minutes to clear the old code. It is working for now .
Oside
Reviewed in the United States on January 8, 2020
Good quality y it works perfectly
Customer
Reviewed in the United States on January 29, 2020
Worked as described on 2002 Toyota 4Runner. Check engine light turned off once installed. Saved a lot of money purchasing this through Amazon. Don’t forget to get the gasket. It is not included.
Robert E Mueller
Reviewed in the United States on June 27, 2019
Loved that it fit right a worked properly no problems whatsoever!!!
Recommended Products