Your cart is empty.
Your cart is empty.Easily load your riding lawnmower, snow blower, wood chipper, or ATV into your shed or garage with these aluminum shed ramps. Featuring a 750 lb. per axle weight capacity and weighing just 4 lbs. each, these lightweight ramps are easy to set up and take down and can be hung on the wall for convenient storage. To permanently mount these ramps, simply bolt them to the floor of your shed using the pre-drilled 1/2" holes. Mounting hardware is not included.These lightweight ramps are easy to pick up and move as needed, and can be hung on a shed wall for easy storage
Michael W Miller
Reviewed in the United States on April 16, 2025
Neighbor got one several years ago. I got the sa.e one (but updated some over the year. Works just fine for my Cub Cadet CC30 in my shed. He has a large John Deere rider. Recommended
Antuane Johnson
Reviewed in the United States on May 18, 2024
After seeing these ramps my wife didn't think that they were going to be able to support the weight of our Bad Boy Rogue 61 in lawnmower but to her surprise they work as well as any heavy duty ramps. They only weigh about 10 pounds so they are easy to move and store. Very sturdy and the perfect length. The only drawback is that it could be a little bit wider but overall it's a great product.
Steven DeMarco
Reviewed in the United States on May 13, 2024
Worked from 4-6 inches. Easy to use. My wife loves them
Brian M.
Reviewed in Canada on November 16, 2023
I am using the ramps to drive a lawn tractor into a shed. These are nice and light to pop into place when needed and to put them back into the shed when not used. Plenty strong for the Cub Cadet XT2 tractor with no damage done after a summer of use.
Phil - Renee
Reviewed in the United States on October 20, 2023
These are perfect to get my 60" mower into our new shed. Sturdy and long enough so the incline wasn't too much. Perfect for what I needed.
Peter Lewsam
Reviewed in Australia on October 31, 2021
Purchased to allow ride on mower access to garden shed. Just the right length/height so that mower clears sliding door track without bottoming-out. Lightweight but well made. Great product.
Sun n Fun
Reviewed in the United States on December 31, 2020
These ramps are perfect for getting my snowblower and lawnmower inside my shed. My shed sits on pavers so the bottom of the door is about 9 inches above the ground and the ramps are long enough so that the angle to climb is not too steep. They are lightweight but also very sturdy. I didn't want to spend $100 or more. These do the job just fine for a much better price.
Annette K
Reviewed in Canada on May 24, 2019
I used this ramp for my riding lawn mower to get into the shed. It is about a 6 inch up from the grass . It is very good quality and is perfect for what I needed. Light weight as well, so easy to store when not using .
Émilie Leclerc
Reviewed in Canada on November 2, 2019
Was received as expected. Sturdy and versatile. We use it to move our snowblower into our shed.
carlos
Reviewed in Mexico on April 17, 2019
Muy buen producto pero mejoraría su robustez
North Coast Joe
Reviewed in the United States on September 27, 2018
I use these to drive my riding mower into my storage shed. I detest the look of an old, stained, and often rotting wood ramp. These are light in weight, easy to store, and do the job well , if placed carefully. Thus, my reasoning for wider ramps. The rear tires on my mower are wider than these, so care needs to be taken to get optimum to get good ramp to wheel alignment. I would buy them again, though.
Miguel Torres
Reviewed in the United States on April 24, 2018
first its light weight. then its sturdy, strong and easy to store. The lip on it lands on the deck perfect for a smooth entry. I use it on my shed to load the riding mower and generator. No issues. No long enough for a truck bed but for a lowboy trailer it should work. I drive my mower up inside and it doesn't give. Well built and I recommend to get it.
TomB
Reviewed in the United States on December 13, 2016
The quality of the ramps is good, I simply miscalculated. I ordered them to be able to get a riding lawn mower into a work shed that is elevated, (sits on skids). The mower deck would not clear the front edge of the shed. So I ended up getting some ramps that are 7.5 feet long and they work perfectly. This would be good advice for anyone else needing to get a riding mower into a work shed that is on skids, and is up approx. 1 to 1 1/2 feet, you'll need ramps at least 7+ feet long. I have found other uses for these ramps, so I am not at all displeased.
Recommended Products
$1,173.96
$ 99 .00 $99.00
$699.00
$ 99 .00 $99.00