Your cart is empty.
Your cart is empty.ARB / OME Leaf Spring Suzuki Sierra F (CS012FA)
larry howard
Reviewed in the United States on March 20, 2025
Brain installation went very well I had no issues with them I'm rebuilding chassis components haven't got to check the level yet
Stanley G. Vial
Reviewed in the United States on April 26, 2024
Old Man Emu by A.R.B. is absolutely the best suspension on the planet.
iamdesigns
Reviewed in the United States on September 12, 2022
It would be nice if the bushings and ubolts were mentioned or in this kit
James F.
Reviewed in the United States on May 28, 2022
I ordered both the front and rear sets for a Suzuki Samurai. Springs arrived on time, as promised, and were well packaged. The installation, while straightforward, does take some time and the proper tools, jack stands, jacks, etc. These should only be installed by an individual knowledgeable of the process, and safety procedures. Otherwise you could have the full weight of a Samurai laying across you chest, and a widowed wife.That being said, I was very happy with the results. I achieved a full 2” lift in the front, and 2.25” in the rear. We will see where it settles out as the springs settle in.Don’t forget, you need to purchase the bushings separately. And you will also need new, longer shocks to accommodate the increased shock travel. Stock length shocks will not work properly.
Joseph
Reviewed in the United States on May 29, 2021
Damaged
Michel gaulin
Reviewed in Canada on March 7, 2021
jai achete ses lames pour une restauration veh et jen suis satisfait
Bill west
Reviewed in the United States on December 21, 2021
Real stiff compared to stock
jacob sedillo
Reviewed in the United States on July 8, 2019
Perfect fit for my stock samurai. New leaf springs lifted the body up 3 inches with stock replacements
Barry
Reviewed in the United States on November 29, 2019
The springs made a world of difference for my Samurai. They gave it about a 2 inch lift.It rides and handles much better now.When installing the springs you will have to enlarge the hole on your stock spring plate/shock mount. The bolt through the spring pack is a little bigger than the one on stock springs. I used a step down drill bit. The description says you need longer U bolts but I had replaced mine a few months ago and they were longer than stock so I didn’t have any trouble. I had already replaced all the bushings and shocks/ steering stabilizer a few months ago, so I just reused them. Adding these springs and installing a 3k Toyota carb are probably the best two mods I’ve done to my Samurai so far.
Recommended Products
$129.99
$ 63 .99 $63.99
$597.99
$ 99 .00 $99.00