Your cart is empty.
Your cart is empty.Product Description
Plug and Play
Fully all in one designed, NO external driver, NO external wire. Directly connected to automotive car socket just like halogen bulbs. Non-polarity plugs, easy to install.
Error Free
Canbus ready, no errors, no flickering, no electromagnetic interference. Plug and play, compatible with most vehicles without modification.
NO Dark Spots
Compare to other bulbs, AUXITO LED narrowed the LED gap to only 0.039in, making the bulbs 360°lighting like oem bulbs. No shadows and no dark area.
How to confirm if these bulbs will fit your car?
1.Enter your car model into the Amazon Garage on the product page to check the compatibility info. Pay attention to the notes to make sure you find the right bulbs for the right beam.
2.You can also search online to find the bulb size for your car.
3.Check the owner’s manual of your car or the original bulbs to confirm the size. (There is a size marker on the surface of each bulb)
Ashley
Reviewed in the United States on March 27, 2025
Used these on my 2019 Tahoe low beams only. Product advertises 50,000 hours of use. This vehicle is seldomly driven and there is no way we reached that many hours of use. Lasted about 1 year before failure. Seems like others had worse experiences. Good while they lasted though.
WG
Reviewed in the United States on January 5, 2025
Work great. No flicker. Super bright. I wish they made an H11b socket too.
Christopher C.
Reviewed in the United States on July 9, 2024
My only concern is the longevity of the product. I have had to replace them every few months!
Mrs. McGurk
Reviewed in the United States on July 27, 2024
Auxito LEDs are standard in my used cars. I've used them now in three of my trucks/SUVs. They are much brighter and safer. Yellow halogen lights are ugly. These are way higher performing. Easy installation in all my cars. Fit is perfect.
Tim
Reviewed in the United States on June 30, 2024
I prefer the normal to bulkier AUXITO housings/fans compared to the slimmer ones with smaller fans as the fans spin either at higher RPM or just make more noise. Although the housing is large, it fit in an impreza and seems to be a little brighter than the M3S. All LED bulbs lose a little brightness after run time (30min) or temperature, I haven't tested yet but I'm sure it will still be bright. Great product!
Blunt Man
Reviewed in the United States on June 23, 2024
Started having flickering a month after being installed. Two weeks ago the right side went out now the left yesterday.
YellowTang
Reviewed in the United States on May 9, 2024
I installed these into a '10 4Runner, very easy. They have lasted over a year so far with no issues. These are extremely bright, much brighter than OEM and much brighter than any of the aftermarket halogen bulbs as well. That being said, the 'cut off' is not 'good'. There is a lot of bleed above the typical OEM light level.Your headlight fixtures needs to be adjusted to use these lights without blinding other drivers on the road or you will get flashed constantly.Do the install at night, pull your vehicle into your garage or need a wall. Turn on your OEM lights and using painters tape to make a level line on the wall where your OEM light stop on the top. Install these LED lights and adjust your headlight fixture down until the cut off is at the same level as your OEM lights.I recommend making note of how many turns it took and either putting it in your phone or on a paper in your glove box should you ever want to go back to the OEM ones, then you can just make the swap anytime.It is amazing how bright these are and how well it lights up the road in front of you....as long as you proberly adjust them!
nick
Reviewed in the United States on December 11, 2023
Plug and play convenience with my 2010 maxima. No flicker, dash lights or anything weird. Seem to out out nice amount of light. I don’t know if the lumens are anywhere close to what is claimed but they are a huge improvement over stock halogens. Gives a nice luxury/ premium appearance of the new OEM mfg led headlights, without the $50k price tag and 6 years of payments.Please use these in projector housings only. They are not made for, and are dangerous for other drivers, in reflector housings.
Recommended Products