Tools required: 10mm Multi-spline driver, extension bar and suitable ratchet.
1. To avoid injury allow the vehicle to cool down fully before starting this installation.
2. Raise the vehicle on a ramp or using a jack and support with suitable axle stands.
3. Using a 10mm Multi-spline driver, extension bar and suitable ratchet undo the 2x bolts on the bush，remove the factory transmission mount bracket
4. Apply Silicone Grease to the legs of the Transmission Mount Insert and press into the factory transmission mount assembly
5. Refit 2x bolts, Torque the factory M8 bolts to 20 NM +90 Degree
