Your cart is empty.
Your cart is empty.Give Your Big Block Mopar Engine a new look with our 254 Piece Stainless Steel Hex Bolt kit!! The bolts in this kit are made from 304 stainless steel. SEND A MESSAGE IF YOU HAVE AFTERMARKET COMPONENTS.
This Bolt Kit is compatible with 383, 400, 413, 426 Wedge, or 440 Mopar Engines.(Non-EFI). This is a high quality stainless steel hex bolt kit. The kit includes individually packaged and labeled component kits for the following items:
Intake Manifold- Valley Cover- Timing Cover- Water Pump- Oil Pan- Thermostat Housing- Distributor- Coil Bracket- Fuel Pump- Valve Covers- Headers- Crank Pulley-Fan Pulley- Carb Stud Kit
The carb stud kit is compatible with Carter, Edelbrock, or Holley Carbs. The studs have an internal hex used to install them in your intake manifold.
Header Bolts (3/8-16 x 1 Allen Bolts) And Our Special Small OD Header Washers Are Included With Each Kit! These extra thick washers are designed to Clear Large Tube Headers.
Customer
Reviewed in the United States on November 4, 2024
They are packaged nicely and look nice but the metal is cheap and it has cost me more money in drill bits and extraction tools to get them back out after they snap off then they are worth.
sean conway
Reviewed in the United States on November 14, 2024
Most r to short, some a little longer but worked
David Kelly
Reviewed in the United States on September 25, 2023
Nice very nice and very well labeled kit. Perfect, great quality. Glad I bought these. Redoing my 440 Mopar again super glad I bought these for my rebuild. Perfect for my show car.
DeltaTech
Reviewed in the United States on November 1, 2023
Well worth it.Ordering this kit is consiterably less hassle and less time consuming as spending 2-6 hours degreasing/wirewheeling/media blasting and rust preventative coating or blueing 50 year old stretched,galled,rusted/corroded bolts!I wish I knew about these 5 years and 5 engines ago! Carb bolts fit a tunnel ram intake with plenty of thread!
Larry skinner
Reviewed in the United States on May 4, 2022
Great product
David S.
Reviewed in the United States on August 20, 2020
Very well packaged, very clean, and look good on my 440!
Chris
Reviewed in the United States on March 17, 2020
Quality bolts with proper machines threads. All bolt worked seamlessly with 1966 ‘B’ 361. Only complaint is the carb studs are too short for use with any placer.
Recommended Products
