Your cart is empty.
Your cart is empty. Black Aluminum Rear Sprocket Pulley Spacers For 1984-1999 Harley Davidson Motorcycles
*** VERIFY THE LIP ON YOUR HUB IS LESS THAN .300" TALL OR THESE WILL NOT FIT ***
Made from billet 6061 aluminum bar stock. Available in graduated sizes for proper spacing when installing oversized custom wheels. Made to fit most 1984-1999 Harley Davidson and custom motorcycle wheels. Typically these fit hubs with Timken tapered bearings, not sealed bearings.
Self-centering design properly locates the spacer to the wheel and the pulley or sprocket
Bolt hole size: .453"
Bolt hole pattern: 3.25" x 5
Counterbore that fits over hub lip: 1.986" I.D. X .300" deep (Except 1/4" spacer is .215")
Step that sprocket/pulley fits over: 1.978" O.D. X .188" tall
Center hole size: 1.19"
Outside diameter: 4.19"
Used with tapered Timken bearings
Fits 3/4 axles
Made in the USA
Made in the USA
