Your cart is empty.
Your cart is empty.Features and Benefits: Size: 3/8". Includes 3 in a pack. Cutters fit 3/8" and 1/2" hand held drill chucks. Made of M2 high speed steel. Made in the USA. This series cut holes 3 times faster and last 10 times longer than twist drills or hole saws, for precision hole making in sheet metal and frame materials up to 1/2" thick. Blair Rota broach annular Cutters make clean, burr-free, round holes with no deforming of stock or damage to the surrounding material. There's no dead zone, so less thrust is required and no deforming of stock or jagged edges occurs. Multiple cutting teeth, precision ground which allows for a long tool life.
Customer
Reviewed in the United States on January 29, 2020
I like the tool very much. It cuts clean. I used it to cut spot welds on autobody work. Excellent tool!
Frank
Reviewed in the United States on February 5, 2019
Worked great. Hundreds of spot welds cut out on one cutter blade and only broke the pilot bit once. Great product!
widget
Reviewed in the United States on September 6, 2016
I had first purchased the 11094 tool to remove some quarter panels a few years back. I used it again last year for another project. The first cutter successfully removed 5 quarter panels in all before I realized it just didn't seem to be up to the task anymore. That was probably 120 spot welds in all, most of which were in less than ideal angles as I was working around wheel wells and body components.I also wasn't very prudent with my drill speeds and rarely used a cutting lubricant.So, I just ordered this set of cutters, and a stick of lube to remove some 1960s spot welds. I'm watching the speed on the drill this time and it is just a joy to work with. Use a good center punch and try to stay square as possible while maintaining good body control.
threewood
Reviewed in the United States on August 22, 2016
These cutters are pretty good, better than the other style. However, they could be better. I found that the drill bit in the cutter doesn't do much drilling and will skip around. To get these to work, I suggest drilling a pilot divot. Also, the 3 that came with my kit didn't go dull but broke off one or multiple cutters making them useless. Even with cutting fluid. They can be sharpened and used again but the blades cracking off was a pain.
Marie and Kevin
Reviewed in the United States on July 29, 2016
Very sharp and aggressive. Second weld in it jumped around, broke 3 cutters off. Stil drilled a whole floor pan out of a Chevy truck bed and half of the replacement bed floor. It was cutting fine still, but I let it walk and broke the last tooth. Replaced with a new cutter, and practiced better drilling technique. That one has done over 100 spot welds, and still cuts great.
Timmer
Reviewed in the United States on January 13, 2016
These worked great for drilling out spot welds on my 78 MGB floor panels. I used the recommended Blair 11750 lubricant while drilling and was able to get about 80 welds drilled out before I felt it was time to change. Also, I was going too deep at first. It doesn't take too much to get through a floor panel.
Dr. Jass
Reviewed in the United States on July 11, 2014
...and worth every penny! Used at low speed (
DO WORK SON
Reviewed in the United States on May 3, 2013
They worked awesome, and do last a long time as long as you use the lube that is meant for them, if you don't use that stuff they burn up extremely fast, trust me i found out the hard way and had to order more. but I'm happy i did.
Recommended Products
$15.99
$ 7 .99 $7.99