Your cart is empty.
Your cart is empty.This is a 18 inch long trailer brake hose line. The rubber flexible hose is DOT approved for hydraulic trailer brakes. This is a high pressure hose rated for drum or disc brakes using surge couplers or electric over hydraulic units. The hose is UV rated to help to keep it from deteriorating in the sun or salt water. The ends are brass 3/16" male inverted flare fittings that use 3/8-24 thread which fit most trailer calipers, wheel cylinders, master cylinders and solenoid valves. The end fittings also swivel which keeps the brake hose from getting twisted while you're tightening up the fittings.
Dahlenburg
Reviewed in the United States on May 29, 2023
Bought 4 of these to replace older set on a boat trailer with electric over hydraulic set up using disk brakes. First one failed going around the block while adjusting the controller. Replaced it with and original as I was leaving for a trip. Had another one fail after 100 miles of the trip. Both failed in the exact same place. Will be taking them all off and looking for something different.
Jos
Reviewed in the United States on April 24, 2023
you can NOT use a proper brake line wrench, only an open end wrench, because there is no room to get the wrench out after tightening it. On the picture it looks ok, with enough room. Probably the guy who assembled it wanted to save some money...Did not return it, because i needed it urgent, otherwise i would have returned it!
sparkymike
Reviewed in the United States on July 5, 2019
Great product. Just can’t find anywhere else
Crzyjeeper
Reviewed in the United States on December 22, 2019
Good fit
Recommended Products
