Shopping Cart

Your cart is empty.

Your cart is empty.

Boost Solenoid Bracket for MAC 3, 4 Port valves Quick Lever Wire Connector

5.0 Write Review
Free shipping on orders over $29.99

$24.00

$ 11 .99 $11.99

In Stock
  • Integrated Waterproof Amphenol integrated Wiring connector , Solder or special crimp...if too difficult choose our Lever type connector version Vibration isolation both to and from the solenoid valve. DOUBLE mounts, will not loosen/rotate like a single mount. Much easier & robust mounting than using the small mac valve holes. The flexibility of the mounts allow mounting to moderately curved surfaces such as wheel wells. Strain relief tie point for the wires. Multiple hole patterns fit ALL of our Genuine Mac 3 & 4 port valves including our High Frequency 4 port and Hi-flow 3 ports. VALVES & pneumatic fittings shown are NOT INCLUDED


CIRCUIT SE7EN Vibration Isolating billet electronic boost control solenoid mounting bracket... Black Hard Anodize. Made in Colorado, USA. This listing is for the mounting bracket that holds genuine MAC valves / electronic boost control solenoid for 35,45&46 series MAC valves, AEM 30-2400, or similar type mac valves (COBB, AMP EFI, GrimmSpeed, Innovate, ect).