Your cart is empty.
Your cart is empty.Bosch Pipe Dies are ideal for cutting right-hand external threads. The hex head shape is designed for use in die stocks and adjustable wrenches. They can be used for threading rods, bolts, and studs. Made from heat-treated carbon steel, they are rust- and tarnish-resistant tools. The hex dies are tooled to the most exacting specifications to ensure that threads provide a tight fit. Laser-etched head shape of the die is designed for use in die stocks and adjustable wrenches; dies measure 1 In. across the flat. They marking indicates starting side, ensures size identification and won’t wear off.
Jose A. Quinones
Reviewed in the United States on May 29, 2024
Just as described
sam
Reviewed in the United States on October 14, 2024
Good quality no issues
Ms. Mellow
Reviewed in the United States on March 24, 2022
I used die to cut 1/8 ips threads on lamp shade support pipe. One face of die is clearly marked to face the work (object to be threaded). The key to success is to very carefully square the die to the work in both directions and then patiently start by turning the die by hand until it grips. Then squirt a little lubricant (WD 40 or 3-in-1 oil) into each hole of die between cutters and proceed slowly. I used a 1" open end wrench to turn the die and cut about 3/4" of perfect threads. I held the pipe (work ) in my vise with rubber pads to prevent scratching. Watch while cutting that work does not turn.Review by Mr Mellow.
Steve L
Reviewed in the United States on April 11, 2022
No issues with ordering, delivery or packaging. This tool works as expected.
Does it come with a filter
Reviewed in the United States on January 11, 2021
Works very good excellent quality for the price cheaper than anywhere else Amazon comes through again
Bob Johnson
Reviewed in the United States on March 13, 2020
Perfect dye for what i needed
hp
Reviewed in the United States on February 17, 2020
I found it didn't really start cutting until further down the piece than I needed... I just need to chase some threads at the very tip and it was useless for that...
mjpsails
Reviewed in the United States on November 25, 2020
Worked wonderfully for threading lighting fixture stems that I had to cut to shorten in order to raise the height from an island. 1/4 to 1/2 turn at a time with some cutting oil or WD-40, back off and clear threads when necessary. I cut 4 sets of 1/8 - 27 npt threads 3/8" with no problems. Slow going but precise.
Recommended Products
$1,348.00
$ 99 .00 $99.00
$104.99
$ 49 .99 $49.99