Shopping Cart

Your cart is empty.

Your cart is empty.

BQLZR Silver R020 Pull Starter Vertex 18 Replacement for Nitro Engine Nitro Pull Start Aluminum Alloy Upgrade Parts for rc CAR

4.7 (13) Write Review
Free shipping on orders over $29.99

$16.99

$ 7 .99 $7.99

In Stock

About this item

  • Note: Do not pull the lever too hard to the end, it may cause it to be unable to retract.
  • For 13.5mm Across Flat Way Bearing, with 6mm shaft diameter.
  • Part No:R020
  • Suitable for RC car with VX 18 Replacement for Nitro Engines.
  • Suit ForVx 16 18 21 Engine
  • NOTE:The distance between the center holes on two sides of the hand puller is 27mm, and the opposite side of the-way bearing is straight
  • Applicable to all brands and proportion models
  • They also look elegant compared to most plastics.
  • Note: The product is all metal. You can wrap your hands with soft cloth or paper towel to avoid pain when your hands touch the metal


Product Description

CAR PULL
easy to install
SIZE
Aluminum

Mel
Reviewed in the United States on May 30, 2024
Good quality it is metal but don't fit my car
Peter Smolik
Reviewed in the United States on March 13, 2024
I was dealing with a low pressure motor and had repetitive pulls and then the string snapped on me and recoiled back inside, it does get hot but felt a lot better than plastic.
Shawn Woods
Reviewed in the United States on November 19, 2024
After trying to start my nitro it failed to retract. In first pull it became loose. Horrible pull start
Mark J. Levy
Reviewed in the United States on January 25, 2024
This pull starter is built really rugged. I used this to replace an outdated, lesser quality starter on my HPI Racing 3.0 engine. This was a perfect addition to that engine. It starts easier and spruces up the looks of any car/truck engine.
Aaron foret
Reviewed in the United States on January 16, 2024
Worked great
Darren
Reviewed in the United Kingdom on September 10, 2023
Wire would not rewind back into pullstart after just 1 pull..
Kyle
Reviewed in the United States on December 26, 2023
I put this on a hpi savage motor. And so far it’s held up great. I went with this one due to the measurements being in the pictures. Worked out perfect
Corey rahn
Reviewed in the United States on April 17, 2023
Fits perfectly works great
Lars Langer
Reviewed in Germany on March 27, 2022
Nach ca 1 Woche und Auto 4 Mal fahren Seilzug gerissen am Griff
Evan
Reviewed in the United States on August 25, 2021
Didn’t last very long won’t retract
sascha möller
Reviewed in Germany on May 4, 2019
Ganz großer Müll , nach Einbau 5mal dran gezogen , und schon war der seilzug ab !!!!Nicht zu empfehlen ....
Seyit
Reviewed in Germany on June 19, 2018
Super
Kunde
Reviewed in Germany on June 29, 2017
Ich habe mir 2 bestellt für meinen 3,5 ccm Buggymotor. Finde Sie sehr gut verarbeitet und wenn man den Motor normal startet und nicht zu viel Sprit im Motorraum ist, hält der auch. Sehen dazu noch edel aus im Gegensatz zu dem meisten Plastikzeug.Ich weiß nicht, was der vor mir der nur einen Stern gegeben hat, gemacht hat?Ich bin sehr zufrieden und benutze immer noch den Ersten von meinen Zweien. Motor bestimm schon 50 mal gestartet und das oft mit nicht nur einem Zug!Deswegen meine Empfehlung zu Preis Leistung.MfG