Your cart is empty.
Your cart is empty.Broilmaster Stainless Steel Bowtie Burner Set For P3 And D3 Gas Grills (Pre-2011 Models). DPP-101. Grill Parts. This Broilmaster replacement bowtie burner is constructed of stainless steel and is for use with the Broilmaster P3 and D3 series gas grills. The dimensions are 9 1/2" width X 17" length (see below note directly from Broilmaster manual) "Note: For P3 and D3 series grills manufactured before 2011: This re-designed burner may be slightly smaller, but is the factory-recommended direct replacement. This burner and orifice combination is rated at 40,000 Btu - the same as your existing burner - and will provide even temperature across the cooking surface.".
Chris H.
Reviewed in the United States on September 2, 2024
The replacement burner is smaller than the original in size however it generates the same BTU’s as the original. This was a simple install and easy way to refurbish the grill. I also replaced the starter and fire rocks. Broilmaster is a high quality grill.
Lisa Vogelpohl
Reviewed in the United States on August 25, 2024
Fit perfectly and easy to install. Went to order one from Broilmaster and there was a 4 week wait. Order thru Amazon and came in 3 days.😃
OldeBeachBum
Reviewed in the United States on August 20, 2024
Comes with the Venturi tubes, you’ll have to attach those yourself, but that’s very easy. Replaced my old burned out bow tie burner perfectly and now my old beat up grill is literally cooking with gas like new.
Jan H.
Reviewed in the United States on July 23, 2024
It was a little smaller than the original. The replacement tubing to put on the gas lines were to big so I had to use the old ones. Once installed the first use it smoked a lot. But now works wonderfully. Ease of installation wasn't to bad.
C. cordo
Reviewed in the United States on July 1, 2024
pros: it was as featured, great fit, works wellcons No problems so far
Larry Jordan
Reviewed in the United States on June 14, 2024
This product is smaller than the original burner. I was concerned that it wouldn't heat the entire grill surface. However, it distributes heat better than the original.
Sharon Raburn
Reviewed in the United States on November 21, 2024
This arrived quickly so we could use our grill again. Seems to last around 4 years. This is the 2nd one we have gotten. Works well.
David L. Cutler
Reviewed in the United States on October 16, 2024
My old burner had rusted out so I purchased a new one.Fit perfectly as expected, but did not come with safety stabilizer.Throws a lot of heat 40K that is evenly distributed. Puts my Weber to shame which only has 32K over a larger surface area.Hopefully this will last for a number of years to justify its cost.
Patrick Chouinard
Reviewed in Canada on July 22, 2021
It fit perfectly
Recommended Products
