Your cart is empty.
Your cart is empty.1-1/2'' diameter, 5/8'' bore with ferrules and square hole caps.
Silvalization
Reviewed in the United States on February 28, 2025
Nice fork handle. I had a question regarding the product and the seller responded immediately and it was resolved.
Roland K. Takayama
Reviewed in the United States on October 28, 2024
Used this item to extend the life of a True Temper compost fork which rusted out as it was being used as a Pismo clam fork. The hole was a little large for the steel fork tang so used a wood shim to tighten the connection. Looks good as new and looking forward to more clam chowder soon.
joseph m
Reviewed in the United States on April 14, 2024
Handle is excellent quality. But was predrilled with a large hole for spading fork head .I had to fill the oversized hole with epoxy to use it.
Silentgrayfellow
Reviewed in the United States on July 6, 2023
Let's see if I can put this one up after I finish with it. I think I might. 🤔
Bruce Kvittem
Reviewed in the United States on November 1, 2022
Nice handle.
Doug Jones
Reviewed in the United States on October 4, 2017
Handles like this one with the tube attached to the wood is very hard to find. Most curved replacement handles do not have the metal attached.In my case, it was the only one that would work.The handle looked very good and was of good quality materials. Should last a long time.
Steve
Reviewed in the United States on September 15, 2016
This was tricky to put on because the shaft of my silage fork that needed to be inserted into the handle seemed way too large. I also did not know how I was going to hammer it on, since the space between the 12 or so tines is so small. I solved this by hooking my wrecking bar over the slide on my large bench vice (a helper with gloves could hold it for you instead) and laying the flat end between the tines and hammering on the wrecking bar instead. By holding the handle upright and off the floor in my other hand, I was able to prevent damage to the D handle. It went on so stubbornly that I have absolutely no fear of it falling off. Hopefully it'll hold up. The wood grain looks straight and continuous so my confidence level is pretty high.
Jean Guy Heon
Reviewed in Canada on March 31, 2016
Very pleased with the quality.Thank you
Douglas G. Smith
Reviewed in the United States on September 12, 2014
High quality. Fit my spading fork very well. Used to dig potatoes after installation and found the handle to be adequate for the bending stress imposed.
Recommended Products
$45.99
$ 24 .99 $24.99