Your cart is empty.
Your cart is empty.Product Description
- This Power Supply Unit "DOES NOT" come with installation instruction, wiring cable, on/off switch, or screws.
- Professional installation of qualified electrician is highly recommended.
- IN-DOOR USE ONLY !
- It is perfect for all 12V LED projects.
- Such as WS2811 / WS2815 / 5630 / 5050RGBW / 5050RGB LED Strip / LED Pixel / LED Matrix / LED String / CCTV Camera / Security System / Computer Project, etc.
Power Supply Wiring Diagram
Please note :
The power cord is not included in the package of this product . If you need a power cord , Please search on Amazon : 3 Prong AC Power Cord .
110V/220V is selected by switch before power on, please check the input voltage avolding damage.
7daysnparadise
Reviewed in the United States on February 18, 2025
Diesel heater 24/7 for several months and not one issue.
Doug B.
Reviewed in the United States on August 6, 2024
This power supply cranks out the amps required.Very good power supply.
Chris Mathus
Reviewed in the United States on August 31, 2024
Use this to power 12v LED strip lights as permanent holiday lights on my home.
T0mW
Reviewed in the United States on July 28, 2024
This supply has very little noise on the unloaded and medium loads. Good supply for powering sensitive electronics, maybe Ham radio?
TheCrusher
Reviewed in the United States on December 13, 2024
It's a small lightweight power supply. Works fine and connection points are fine as well. Problem arises when a dimmer is attached and dimming is applied, the more dimming that is applied, the louder the whining coming from the power supply. If I remove the dimmer or set it to 100% brightness, everything is fine.I'm running four different rails of 8mm COB lights with identical lengths of 6-feet at 12VDC. The lights are drawing 2.6 Amps when undimmed. Dimming the lights by 90% creates a noticeable whine as it draws 0.25 Amps.
Bruce Poore
Reviewed in the United States on April 26, 2024
Add a power cord and Anderson power poles to supply your power to a radio 📻 and your good. Adjustable voltage.
Andrew Dixon
Reviewed in the United States on December 27, 2023
This is the quickest way to breathe new life into a failed multichannel power supply. Only issue I had was I would prefer if the DC side was on the opposite end as that's where the one I replaced had theirs. No big deal really just meant I had to put some longer cables.
Dario
Reviewed in Italy on May 29, 2022
Il prodotto é valido anche se non l’ho provato alla massima potenza disponibile.L’unico inconveniente é un fischio continuo se utilizzato con un controller luci led con dimmer.Utilizzando un altro alimentatore (IP67 come categoria di protezione) il fischio é scomparso.L’ho restituito ed é stato rimborsato.
Kari Olavi
Reviewed in Germany on November 21, 2021
Works very well. The AC power line socket should be better protected. If it get loose from the socket it is very dangerous even fatal with high voltage!
Priyank
Reviewed in the United States on September 9, 2020
Bought this Power supply to feed my DIY laser engraver. It is not the thinnest one but is also not as thick as other similar rating PSUs. Out of the box it does deliver 12.1V and my 20w laser works at its optimal level hence I think the amp rating is also as mentioned, although I do not have proper tools to measure max amps rated on the PSU. I still have to make case for it but as far I matched, it does have similar screw footprint as my meanwell prower supply hence I can say it is generic replacement to any other brand powersupply.
Recommended Products