Your cart is empty.
Your cart is empty.Your Jeep Wrangler is made for getting off the beaten path. So make it stand out from the crowd with custom-built Trail Armor from Bushwacker. Trail Armor combines trail-proven toughness with state-of-the-art Dura-Flex 2000 TPO material for a look all its own. Dura-Flex 2000 TPO is our proprietary automotive protective material, ruggedized for extra durability and flexibility. Unlike steel, it can’t rust...and, unlike lesser products, it’s 100% UV protected to prevent chalking. We make everything right here in the USA, designing to the tightest tolerances for a factory-like fit. Installs in minutes with automotive-grade 3M adhesive, no drilling needed. Trail Armor is backed by our Limited Lifetime Warranty. Your Trail Armor starts out looking tough, and lives up to its looks year after year.
Paul O
Reviewed in the United States on September 8, 2024
Holes all lined up with no trimming. Pressure sensitive adhesive was too aggressive so recommend leaving on the masking until it is in place. I used the tail lights and fuel bezel to hold in final position then removed masking from adhesive. License plate square nuts had too much clearance and would spin in opening, used electrical tape to take up space.
Customer
Reviewed in the United States on March 13, 2023
This product requires modification to fit a 2001 Jeep wrangler. Specifically, the gas cap hole does not line up with the vehicle's hole. It works after drilling different screw holes and then enlarging the Armor's hole toward the front of the vehicle. The modification left one of the original screw holes in the armor partially uncovered.
Linda Hansen
Reviewed in the United States on July 26, 2021
I had a small dent on the right rear corner of my jeep. I had it rollered out as much as possible but the dent was still visible. I put the Bushwacker corner panels on to cover the dent and to add a little flare. They were easy to put on in about an hour and they do look good. Just make very sure that you have the corners exactly where you want them because when that 3M tape contacts the surface of the jeep it is pretty much permanent.
dawn
Reviewed in Canada on March 10, 2021
Hubby is pleased and easy to install and he loves the look of them.
Bill
Reviewed in the United States on August 25, 2020
My 2000 tj looks good, back right could be closer to hinges
alawneda
Reviewed in the United States on July 15, 2020
Drivers side fit perfectly, passengers side was a bit more tricky, once the lights were bolted back on, passengers side had a gap at the top, filled it with some black sealant caulking and that did the trick. Would recommend sealing the 3M tape before tightening the lights back on. Otherwise they look kick ass.
Jordan
Reviewed in Canada on March 26, 2018
As Advertised good fitment
P. Nelson
Reviewed in the United States on June 7, 2017
Very nice-looking panels, and installation could not have been more straightforward and easy! Nice way to dress her up!
Crystal Hill
Reviewed in the United States on August 20, 2015
Purchased corner guards to hide a dent on passenger side. These were easy to install and all the holes line up perfectly. They are plastic but look cool and well made. Only gripe I have is the bottom corner of the license plate area is not a clean looking area and is material is thin there.
normand
Reviewed in Canada on June 15, 2015
cote gauche parfait ,cote droit couper trop court alentour des pentures
Harvey P.
Reviewed in Canada on April 9, 2015
very good deal
Daniel
Reviewed in the United States on February 24, 2014
I purchased these to cover a small dent. I also purchased replacement taillights and together it looks sharp. It is plastic but looks durable. Comes with 3m adhesive and has screw holes molded in for the tail lights to go in. On the driver side, the armor has molded holes for the tag. So, not only does it 3m tape, it has screws to hold it in. I can't say enough how good this looks. I am really proud of how it turned out! I would recommend to a friend. They really are a good deal.
shawn Elliott
Reviewed in Canada on December 7, 2014
After contacting Bushwacker directly asking for the part # that I needed. This part does not fit my 2005 Jeep LJ
Recommended Products
$108.99
$ 45 .99 $45.99
$139.99
$ 67 .99 $67.99
$97.80
$ 38 .99 $38.99
$102.50
$ 47 .99 $47.99