Your cart is empty.
Your cart is empty.Buyers Products Standard Size Flush Mount Non-Locking Paddle Latch is a single point latch built to handle the demands of daily use. The non-locking, rectangular latch is designed to mount into a 3-3/8 in. by 4-5/8 in. recess and is available in rust-resistant steel (welded on) or stainless steel (bolted on).
jeremy richards
Reviewed in the United States on January 13, 2025
Just what I needed to replace latches and locks on a service truck think it was a reading bed
Customer
Reviewed in the United States on November 9, 2024
It installed easily and replaced the existing latch perfictally
Tim Finnegan
Reviewed in the United States on January 8, 2024
It's the same as what was on my utility bed, but they seem lighter duty. I looked, and there aren't many choices for these latches; they will work for now.
nate
Reviewed in the United States on March 8, 2023
Great price. Perfect fit. Direct replacement. Been searching for years. Thank you!
travis
Reviewed in the United States on November 26, 2023
Seems to be a good product and would purchase again
Henry D Peters Jr
Reviewed in the United States on September 1, 2022
Works like it should. Fit my truck boxes. Only have a couple to replace. I will be buying these again.
jean-pierre belanger
Reviewed in Canada on March 5, 2021
sait made en china
T. White
Reviewed in the United States on November 5, 2019
I purchased four of these latches to replace latches on two tow trucks that I own. They were better quality than the latches that I replaced. They are constructed well and function as intended. I installed all four latches with rivets at the mounting points. This technique worked well for mounting the latches securely.
Dean
Reviewed in the United States on March 29, 2017
They're doing the job as expected--the only reason I clipped a star is the bolt.1.) it's a little loose (or should be a little longer) and it will tilt a bit, allowing the door to open just a crack. Maybe I could try adjusting the strike plate, but then it might not catch as easily.2.) it's a (plated) casting, and the bolt's "back" face is rough enough that it hangs up and keeps the lid from slamming and catching (have to flip the lever and retract the bolt to engage). Since it's plated I didn't want to sand/file the bumps off and lose corrosion protection. Again, I might be able to file the front edge of the strike plate to round it a little, but don't really expect that would work.Otherwise, these work fine and look great. Hoping they last for a long time.Edit: after a couple of weeks the action of the lever was a little rough so I decided to give them a shot of white lithium grease. Wow. They still won't slam but they open like butter! That might help keep moisture out too. 4.5 stars
Recommended Products
$15.88
$ 6 .99 $6.99