Shopping Cart

Your cart is empty.

Your cart is empty.

CAN Bus Y-splitter (6') for Holley EFI - Sniper - Terminator X - Dominator Replaces 558-465

4.5 (2) Write Review
Free shipping on orders over $29.99

$39.99

$ 20 .99 $20.99

In Stock
  • CAN Bus Y-splitter
  • Fits Holley EFI, Sniper, Terminator X, Dominator
  • Replaces 558-465


CAN Bus Y-splitter for Holley EFI, Sniper, Terminator X, Dominator replacing 558-465 allows you to add an additional CAN device to your Sniper EFI or Terminator X installation, without needing to unplug the handheld. This easy to install CAN splitter simply plugs into the CAN connector on your main harness, then allows you to plug in any Holley EFI CAN device, such as a Digital Dash, or USB to CAN communication cable.


Customer
Reviewed in the United States on April 22, 2022
nice quality. works with holley sniper cable and PC with no issues.
Michael Case
Reviewed in the United States on April 20, 2022
Make sure the connector is seated all the way. Could not figure out why my laptop wouldn’t sync to my terminator x. The connection was good enough for the laptop to recognize something was plugged in but it would not sync. Found the connector was not pushed in far enough. After that it works flawlessly.