Your cart is empty.
Your cart is empty. Carbhub MS200 Carburetor for Stihl MS200 MS200T 020T 020 Chainsaw Carb with Air Filter Fuel Line Hose, C1Q-S126B Carburetor Replace 1129 120 0653, MS200T Carburetor
Compatibility:
Carburetor Replaces # C1Q-S126B
Carburetor Replaces # 1129 120 0653
Fits Stihl MS200 MS200T MS 200 MS 200T 020T 020 Chainsaw
Package list:
1x Carburetor
1x Air Filter
1x Fuel Line w/ Vent
1x Fuel Filter
1x Spark Plug
2x Gaskets
You will receive as picture showed
Note:
1. This is an Aftermarket replacement part Not OEM
2. Please kindly check the models and pictures provided to ensure fitment. If you are not sure, please email us firstly.
D
Reviewed in the United States on February 14, 2025
I rebuilt a stihl 200mst and this carb was perfect right out of the box. Thanks
alan J mundy
Reviewed in the United States on October 2, 2024
works great
TML
Reviewed in the United States on June 14, 2023
As my 020T carb only had 1 screw to adjust the high and low adjustment.This carb has 2 but my Stihl saw did have the knock outs to add the 2 screw adjustments..So all in all it went in well.. Everything fits.. Runs like it was brand new again..Great little carb kit .. Thank You
GFoss Jr
Reviewed in the United States on May 7, 2023
After getting the carb back to factory settings an a little bit of adjustment and doin the minor maintenance on the rest saw runs like new and when you 70 80ft up in a tree a reliable saw is an arborist best friend
Bruce Roedel
Reviewed in the United States on February 18, 2023
I had a lot of fallen branches to cut after a big storm but saw wouldn’t start or run without stalling. This kit fixed it.
ElectMech
Reviewed in the United States on May 20, 2022
This carburetor didn't work out of the box. The saw that I installed it on would not idle. Upon closer inspection I found that the throttle butterfly on the original carburetor had a small notch in it. I was able to swap it with the one in the new carburetor and then the engine would idle.
Brian C
Reviewed in the United States on November 5, 2022
Original carb on my trusty old Stihl MS200T climbing saw finally crapped out, initially was going to just order a rebuild kit but decided to go with the entire carb for a couple reasons/advantages: (1) No fooling with tiny parts (2) Mixture screws have no stops like the factory carb, so can really dial it in (3) included a base gasket (not really needed with the Stihl rubber manifold but good insurance against vacuum leaks). Extra stuff included that I did not need or use: new tank supply/vent lines, 2 different clunk/filters, crank pulse line and a cheap spark plug. Only downsides are: (A) spark plug gap is huge and the bendable electrode is too far from the center electrode to properly gap without angling it, (B) new tank vent/restrictor is not included and (C) sending money to China. 5 stars regardless.Swapped it out (a good time to tear down the saw and clean oily sawdust gunk), pulled the rope 3 times and she sprang to life. A little warm up time and a few turns of a screwdriver to tweak the mixtures and idle and the saw runs like new, smooth response from a nice slow idle through midrange and up to an edge-of-lean full throttle scream.
Recommended Products
