Your cart is empty.
Your cart is empty.Jacquelene S Hallman
Reviewed in the United States on March 16, 2025
Great carburetor this one is the right one ☝️
aphe835
Reviewed in the United States on February 4, 2025
The media could not be loaded.
Maureen
Reviewed in the United States on January 10, 2025
Started right up with no issues.
Vincent
Reviewed in the United States on May 19, 2024
The The carburetor was delivered quickly. The carburetor was as described. The carburetor was easily installed with just a few tools. The snowblower runs great now.
Customer
Reviewed in the United States on February 16, 2024
Works great for my snowblower
good one
Reviewed in the United States on December 2, 2024
nicer if there is picture of where to put all parts, but you can guess.
Fred
Reviewed in the United States on January 2, 2024
Bolton ran greatThanks
RUthatoneguy
Reviewed in the United States on December 20, 2023
I installed this carburetor and primer on a non-starting Toro 518ZE snowblower. Mission accomplished: Snowblower started right up after a few priming pumps, ran smoothly.There were a few slight frustrations. The biggest was that the fitting for the gas line on the new carburetor was slightly lower than on the original one. I had to enlarge the cutout where the gas line goes through the plastic shroud as shown in the picture - a couple snips with a diagonal cutter. The other was that the holes on the replacement spacer block that goes between the carb and engine block were a little too small to clear all of the mounting studs. Not a big deal, I reused the old spacer. Those don't tend to wear out or get damaged anyway. On the 518ZE there's no room to fit the included fuel filter nor was there a filter originally. I saved that for another use.A fine, economical fix that got the little snowblower back on the job, ready for the next blizzard. 5 stars!
Recommended Products