Your cart is empty.
Your cart is empty.Eric
Reviewed in the United States on December 11, 2024
Worked well nice fit
JCox
Reviewed in the United States on January 18, 2024
No complaints.
Travis Hawley
Reviewed in the United States on April 20, 2024
This is probably the best aftermarket carb kit other than stens or OEM that I have ever used. Definitely will buy again. You door have to exercise the rubber oring a bit to make it sit in the groove nice but other than that great product for the money.
Customer
Reviewed in Canada on August 5, 2023
Easy to install every was as stated
Marty
Reviewed in the United States on July 15, 2022
No problems. Everything fit.
BASIL H.
Reviewed in the United States on February 8, 2022
DID THE JOB
Customer
Reviewed in the United States on December 2, 2022
Fit and works great
Matt
Reviewed in the United States on April 14, 2022
When putting on the O-ring type gasket, it is a little small. It stretches into place but popped out over and over and over. So you need to use all your fingers to get it on but then it’ll just pop out.Here’s the six: Get some dielectric grease or even axle grease and put grease in the groove and grease up the gasket. Once you get it in place, the grease will suction it in long enough for you to put the other gasket on and the bowl. Before tightening the bowl make one final inspection to make sure it didn’t spring out. Next, use channel locks to hold the bowl so that it does NOT spin. If it spins, chances are the edge of the bowl will torque the gasket and ruin it.
J.D 89
Reviewed in the United States on February 24, 2021
Product I received was good quality and marked “Made in Brazil” on the package. Used on Kohler K321.
Recommended Products
$39.95
$ 19 .99 $19.99
$83.66
$ 32 .99 $32.99