Your cart is empty.
Your cart is empty.
Model: CBB60
Material: Metallized polypropylene film
Capacity: 16uf
Type: - 40/70/21
Rated voltage: 450V AC
Frequency: 50 / 60Hz
temperature coefficient : 25/85/21
Color: white
material : metallized polypropylene film
Body size : 4 x 7.3Cm/1.6" x 2.9 inch (D * H); wire length : 21Cm/8.3"
material : metallized polypropylene film
Package Content :
1 x motor capacitor
John
Reviewed in the United Kingdom on September 2, 2024
Fixed pool pump
Mr John Robertson
Reviewed in the United Kingdom on September 8, 2023
Worked perfectly for replacing a blown capacitor on an Arctic Spa hottub
Hopkins
Reviewed in Mexico on September 4, 2023
Apenas lo conecté y vi que ya funcionó la bomba pero como siempre entrega tarde por parte de Amazon
Michael Kern
Reviewed in the United States on August 21, 2023
I took a chance that this was the right capacitor. It was, and now my drill press works like new.
Janet Roberts
Reviewed in the United States on May 19, 2023
Not sure if picked wrong , but does not look like what is advertised. Very disappointed
Customer
Reviewed in the United Kingdom on November 30, 2023
Great service
Antonio ERETTA
Reviewed in Italy on January 25, 2023
Ripristinata una pompa ad immersione di marca dopo 20 anni di funzionamento con una spesa irrisoria. Ovviamente il lavoro è stato fatto dal sottoscritto dopo verifica di fattibilità.
Ibuyamazon
Reviewed in the United States on February 19, 2021
I ordered this for my Delta 28-185 Bandsaw that I found at a garage sale for $20. It would start but would slow down & the motor got pretty warm. I tried this capacitor (motor is permanent capacitor type) even though it was 450 V. I hoped I would be able to cut the case and find a smaller capacitor potted inside like reviewer Michael did because this was too big for the bench top band saw's motor capacitor mount. I could see daylight at the bottom of the case so I sawed it off (see photo) but this capacitor filled the entire case diameter. I taped it back together and strapped it to the motor. The bandsaw would not start but if I spun one of the blade wheels it would run. I don't think I damaged the innards by sawing but maybe I did. I don't know why it is so hard searching for the correct capacitor but I was able to find one on eBay. It is the gray one in my photos and the seller is "luck-jade". It was 2-1/2" long and the OEM was 2" but there is just enough room under the capacitor mount cover for it to fit. It worked and the band saw starts and runs fine. Hope this helps someone.
craig barcomb
Reviewed in the United States on November 9, 2021
Works fine just should of checked size however works fine good price will get others for other tools that need
Michael
Reviewed in the United States on December 2, 2020
This was longer and wider than the capacitor I needed to replace for my Delta bench-top bandsaw. Someone else mentioned in a review that they had shortened the case so I tried it. I shone a bright light through the case and could see that the actual capacitor was very loosely potted in the exterior white case. I cut off the very end of the case and managed to pull out the much smaller actual capacitor. I wrapped it in electrical tape to protect the wire connection to the capacitor, slapped a label on it to remind myself of the capacitance and voltage and installed it on my saw. I wouldn't recommend this approach to everyone but if you know what you're doing, it's an option.
Recommended Products
