Shopping Cart

Your cart is empty.

Your cart is empty.

CD14538BE CD14538B CD14538 CMOS Dual Precision Monostable Multivibrator Breadboard-Friendly IC DIP-16 (Pack of 10

5.0 Write Review
Free shipping on orders over $29.99

$12.49

$ 5 .99 $5.99

In Stock
  • The CD14538B dual precision monostable multivibrator provides stable retriggerable/resettable one-shot operation for any fixed-voltage timing application.
  • Retriggerable/resettable capability, Trigger and reset propagation delays independent of RX, CX, Triggering from leading or trailing edge, Maximum input current of 1 µA at 18 V over full package-temperature range; 100 nA at 18 V and 25°C, 5-V, 10-V, and 15-V parametric ratings
  • Q and Q buffered outputs available, Separate resets, Replaces CD4538B Type, Wide range of output-pulse widths, Standardized, symmetrical output characteristics
  • Schmitt-trigger input allows unlimited rise and fall times on +TR and -TR inputs, 100% tested for maximum quiescent current at 20 V, Noise margin (full package-temperature range): 1 V at VDD = 5 V, 2 V at VDD = 10 V, 2.5 V at VDD = 15 V, Meets all requirements of JEDEC Tentative Standard No. 13B, "Standard Specifications for Description of 'B' Series CMOS Devices"
  • Example Applications: Pulse delay and timing, Pulse shaping


The CD14538B dual precision monostable multivibrator provides stable retriggerable/resettable one-shot operation for any fixed-voltage timing application.
An external resistor (RX) and an external capacitor (CX) control the timing and accuracy for the circuit. Adjustment of RX and CX provides a wide range of output pulse widths from the Q and Q\ terminals. The time delay from trigger input to output transition (trigger propagation delay) and the time delay from reset input to output transition (reset propagation delay) are independent of RX and CX. Precision control of output pulse widths is achieved through linear CMOS techniques.
Leading-edge-triggering (+TR) and trailing-edge-triggering (-TR) inputs are provided for triggering from either edge of an input pulse. An unused +TR input should be tied to VSS. An unused -TR input should be tied to VDD. A RESET (on low level) is provided for immediate termination of the output pulse or to prevent output pulses when power is turned on. An unused RESET input should be tied to VDD. However, if an entire section of the CD14538B is not used, its inputs must be tied to either VDD or VSS.
In normal operation the circuit retriggers (extends the output pulse one period) on the application of each new trigger pulse. For operation in the non-retriggerable mode, Q\ is connected to -TR when leading-edge triggering (+TR) is used or Q is connected to +TR when trailing-edge triggering (-TR) is used. The time period (T) for this multivibrator can be calculated by: T = RXCX.