Your cart is empty.
Your cart is empty.The CDI Electronics 134-9021-3 Mercury/Mariner Trigger fits the following 1987-1999 3 cylinder engines: 45 JET, 50, 60, 65, 70, 75, 80 and 90 HP. Replaces part numbers: 99021A15, 99021A16, 99021A13, 99021A 8, 99021A 3, 99021A 5.
Logan
Reviewed in the United States on July 20, 2024
Plug and play would definitely buy again
Hernan Luis Foschiatti
Reviewed in the United States on April 8, 2024
El envio y el producto todo en perfectas condiciones. funciono correctamente tal cual lo informado por el vendedor.
Customer
Reviewed in the United States on September 1, 2023
good parts
Kandi Almanza
Reviewed in the United States on May 20, 2023
Two months and the trigger already went out now my boat is down and I'm losing money
rod blais
Reviewed in Canada on June 5, 2022
This did not fit the inside diameter was too high and would not allow to move freely. Had to order new one from a merc dealer. Still waiting
Barbara Jessip
Reviewed in the United States on July 22, 2021
CDI is a trusted name for quality outboard parts. My motor is back on the water again.
Malinda
Reviewed in Canada on July 18, 2020
Good
douglas caple
Reviewed in the United States on January 17, 2020
Motor started right up ..used this on a 3cyl 60 HP mariner. The pigtail is just a tad short I will need to splice some wire on to it but it fired right up and ran fine (I temp spliced some wires to the connections to do a test start before I cut the ends off and splice in extra wire.) Not sure if they have one with a little bit longer wire but this one works fine
Sherri P
Reviewed in the United States on September 17, 2018
replaced unit on 1988 90 hp mercury 3 cylinder 2 stroke. Instantly made engine run good and strong. can't go wrong with this one. Suggest getting a flywheel removal tool.
Jeff
Reviewed in the United States on November 2, 2018
Well made product
Recommended Products
$28.99
$ 14 .99 $14.99
$19.49
$ 8 .99 $8.99