Shopping Cart

Your cart is empty.

Your cart is empty.

CMT 816.064.11 Panel Pilot Bit with Guide, 1/4-Inch Diameter with 1/4-Inch Shank

Free shipping on orders over $29.99

$14.85

$ 7 .99 $7.99

In Stock

About this item

  • 3/4-Inch Cutting Length, 2-1/2-Inch Cutting Length.
  • The bit point plunges smoothly and easily, the carbide-tipped edge cuts clean and fast.
  • PTFE-coated to protect the bit against resin, pitch and other residue.
  • Make openings in paneling, drywall, siding, doors or windows quickly.
  • Great for trimming formica, veneer and other laminates.


Make openings paneling, drywall, siding, doors or windows quickly. The point plunges smoothly and easily and the carbide edges cut clean and fast. All of this adds up to accurate cuts in less time and with less effort - great for trimming formica, veneer and other laminates. CMT orange bits have been rated the #1 overall router bits compared to other brands (Wood Magazine).


Customer
Reviewed in the United States on February 24, 2023
1/2” osb didn’t make it around one whole window. Dulled and about on fire. Junk.
joe
Reviewed in the United States on April 9, 2023
I bought this to route out some T1-11 and the cutting area isn't even 5/8" so that doesn't work
travis holt
Reviewed in the United States on December 15, 2020
Lasted a total of 15 before half of the flute broke
Customer
Reviewed in the United States on July 23, 2018
It’s is a single flute. The picture is very misleading.
Kindle Customer
Reviewed in the United States on April 26, 2018
Picture shows two carbide bits but only has one. I think this is false advertising and not happy with the product. Was thinkingabout buying the other pieces but now I'll have to rethink that.
Aaron
Reviewed in the United States on March 6, 2015
I almost cancelled my order after reading the review commenting on the single carbide side. Wish I had, because the bit I received had no carbide whatsoever. Garbage bit in a pretty orange dress. Guess that's what I get for ignoring had reviews.
scott spiess
Reviewed in the United States on June 24, 2014
I have bought CMT for a couple decades. Never been disappointed. Wish the price could be a little lower, but still worth it.
L. Grimaldi
Reviewed in the United States on December 2, 2013
Picture shows two carbide cutter edges but there is only one. Somewhat slower feed rates are needed for smooth finish. Not worth returning and it works OK (only OK).