Your cart is empty.
Your cart is empty.
AN6 Automatic Transmission Cooler Line Kit For 4L60E 4L65E - Black Nylon Braided Hose Kit
Compatible with 4L60E 4L65E Transmission
The oil hose is made of CPE rubber inner core, with a layer of 304 steel wire and nylon outer braid; the hose adapters are made of high-performance aluminum alloy.
blake garner
Reviewed in the United States on August 11, 2024
Did not fit my radiator or my 4l60e transmission. The fittings stripped out threads on radiator and to small to seal in transmission
Mervay
Reviewed in the United States on February 26, 2024
China junk fittings. Buy better fittings.
Eddie Gonzalez
Reviewed in the United States on February 14, 2024
I wanted it for 93 GMC LS swap, didn't really work for what I needed it, too snug between body and transmission, plus you also need the adapter that go into radiator, the AN fittings will not screw in by themselves, but did use it in 79 Trans Am with 700r4 and it worked great
DANINE WILSON
Reviewed in the United States on April 24, 2024
Purchased this for the hose and the trans fittings. Hose quality seems normal. Tried using the swivel fittings since it came with it but the machine quality is rough. The female ends don’t want to spin to screw on and I had to loosen them up with wd40 and a wrench. I used 2 of them in a place easy to access in case I have to replace them. Fingers crossed they don’t leak.
Marcus
Reviewed in the United States on September 19, 2023
The fittings worked perfect to adapt to -6 for my 4l60e but the elbow -6 fittings were very sloppy and low quality… they wouldn’t seat right and had a leak so I had to wait for some higher quality ones to come in.. other wise eveything else was of good quality and be sure to measure twice cut once they I only had about half a foot left said and done
hotbld
Reviewed in the United States on December 21, 2023
It is junk tryed to put radiator fittings in And it stripped my threads out of my brand new $650 radiator do not buy
Brandon Farr
Reviewed in the United States on October 9, 2023
The threads are wrong, it does not fit and chevy transmission.
EricR
Reviewed in the United States on April 26, 2023
Do not use an angle grinder with a cut off wheel to cut the tubing to length. I bought two different kits to do my transmission lines, and the instructions in one of the kits said to use a cut off wheel. The cut off wheel creates a lot of burnt rubber dust which goes right into the tubing. Quick way to ruin a freshly rebuilt transmission (in my case). Otherwise, the tubing and fittings seem of decent quality and I would buy this again.
Recommended Products
